1
Tuscany Fire Table—Manual and Installation Instructions
Revised 8/4/2010
2
Introduction: Thank you for your purchase from The Outdoor GreatRoom Company. We are
sure you’ll enjoy many evenings gathered around the fire. The Tuscany Fire Table surround is
manufactured to be used with the Crystal Fire Pit Burner Assembly. This item is not included
with the Tuscany Table packaging. Parts shown in this manual are from both the Tuscany Ta-
ble and the Crystal Fire. Outdoor GreatRoom company recommends visiting with your local
authority for building codes, restrictions, or requirements for this product. Please read the man-
ual through before starting the project.
Material: This firepit is manufactured of GFRC. Glass Fiber Reinforced Concrete (GFRC) is a
proven engineered composite building material consisting of Portland cement, aggregate, color
pigments, and glass fiber reinforcement. The glass fibers reinforce the concrete, much as steel
reinforcing bars do in conventional construction. The glass fiber reinforcement results in a
product with much higher flexural strength than normal concrete, allowing its use in thin-wall
casting applications.
Warranty: This product is guaranteed to be free from manufacturer’s defects for 1 year from
date of purchase. The warranty is void if the product is found to be altered, misused, or improp-
erly maintained.
Technical and Gas Specifications: For technical specifications regarding the Crystal Fire model
number CF-20-LP, please refer to the manual included with that unit. You can also find this by
visiting http://www.outdoorrooms.com/manuals
Important:
• Read instructions prior to assembly
• Assistance is required and we recommend at least 2 people for installation
• If you have questions contact the place of purchase or The Outdoor GreatRoom Co at
866-303-4028
Disclaimer—The Outdoor GreatRoom Company is not liable for damage caused by
weather or misuse
3
Tuscany Fire Table Base
Tuscany Fire Table Top
Tuscany Fire Table Door
Tuscany Fire Table Control Panel
Parts List
4
Step 1:
Set the base in place
Step 2:
Install the control panel
NOTE: There are no screws necessary for the
installation of the control panel. This is a fric-
tion fit control panel. It may be necessary to
slightly bend out the inner tab to fit around the
base.
Step 3:
Set the control panel in flush.
5
Step 4: Connect the gas supply flex line
NOTE: To ensure proper connections contact
your local gas authority.
Step 5: Connect the propane hose with
regulator.
NOTE: To ensure proper connections contact
your local gas authority.
Step 6: Install the push button sparker from
the Crystal Fire.
6
NOTE: Remove the plastic nut, to expose the
brass grounding contact point. Then replace
the nut, install a AAA battery, and cap.
Step 7: Install the cap and hand tighten.
Step 8: Install the top so that it is centered on
the base.
NOTE: For a more permanent installation, it is
suggested to run a bead of exterior grade
silicone to adhere the top to the base.
7
Step 10: Connect the gas supply flex line to
the Crystal Fire.
NOTE: To ensure proper connections contact
your local gas authority.
Step 9: Install the Crystal Fire.
Step 11: Connect the ignition wire to the back
of the sparker module.
8
Step 12: Connect the propane hose the to
prone tank.
NOTE: Propane tank not included.
NOTE: To ensure proper connections contact
your local gas authority.
Step 13: Put the door in place to conceal the
propane tank
Step 14: Place the tumbled glass on top of the
Crystal Fire.
9
Igniting the Crystal Fire: Make sure the con-
trol panel valve is turned to OFF. After this is
confirmed, turn on the propane tank.
Depress the push button ignition and slowly
turn the control panel valve to ON to ignite the
unit.