Tuscany Fire Table—Manual and Installation Instructions Revised …€¦ · manufactured to be used with the Crystal Fire Pit Burner Assembly. This item is not included with the

1

Tuscany Fire Table—Manual and Installation Instructions

Revised 8/4/2010

2

Introduction: Thank you for your purchase from The Outdoor GreatRoom Company. We are

sure you’ll enjoy many evenings gathered around the fire. The Tuscany Fire Table surround is

manufactured to be used with the Crystal Fire Pit Burner Assembly. This item is not included

with the Tuscany Table packaging. Parts shown in this manual are from both the Tuscany Ta-

ble and the Crystal Fire. Outdoor GreatRoom company recommends visiting with your local

authority for building codes, restrictions, or requirements for this product. Please read the man-

ual through before starting the project.

Material: This firepit is manufactured of GFRC. Glass Fiber Reinforced Concrete (GFRC) is a

proven engineered composite building material consisting of Portland cement, aggregate, color

pigments, and glass fiber reinforcement. The glass fibers reinforce the concrete, much as steel

reinforcing bars do in conventional construction. The glass fiber reinforcement results in a

product with much higher flexural strength than normal concrete, allowing its use in thin-wall

casting applications.

Warranty: This product is guaranteed to be free from manufacturer’s defects for 1 year from

date of purchase. The warranty is void if the product is found to be altered, misused, or improp-

erly maintained.

Technical and Gas Specifications: For technical specifications regarding the Crystal Fire model

number CF-20-LP, please refer to the manual included with that unit. You can also find this by

visiting http://www.outdoorrooms.com/manuals

Important:

• Read instructions prior to assembly

• Assistance is required and we recommend at least 2 people for installation

• If you have questions contact the place of purchase or The Outdoor GreatRoom Co at

866-303-4028

Disclaimer—The Outdoor GreatRoom Company is not liable for damage caused by

weather or misuse

3

Tuscany Fire Table Base

Tuscany Fire Table Top

Tuscany Fire Table Door

Tuscany Fire Table Control Panel

Parts List

4

Step 1:

Set the base in place

Step 2:

Install the control panel

NOTE: There are no screws necessary for the

installation of the control panel. This is a fric-

tion fit control panel. It may be necessary to

slightly bend out the inner tab to fit around the

base.

Step 3:

Set the control panel in flush.

5

Step 4: Connect the gas supply flex line

NOTE: To ensure proper connections contact

your local gas authority.

Step 5: Connect the propane hose with

regulator.



Step 6: Install the push button sparker from

the Crystal Fire.

6

NOTE: Remove the plastic nut, to expose the

brass grounding contact point. Then replace

the nut, install a AAA battery, and cap.

Step 7: Install the cap and hand tighten.

Step 8: Install the top so that it is centered on

the base.

NOTE: For a more permanent installation, it is

suggested to run a bead of exterior grade

silicone to adhere the top to the base.

7

Step 10: Connect the gas supply flex line to

the Crystal Fire.



Step 9: Install the Crystal Fire.

Step 11: Connect the ignition wire to the back

of the sparker module.

8

Step 12: Connect the propane hose the to

prone tank.

NOTE: Propane tank not included.



Step 13: Put the door in place to conceal the

propane tank

Step 14: Place the tumbled glass on top of the

Crystal Fire.

9

Igniting the Crystal Fire: Make sure the con-

trol panel valve is turned to OFF. After this is

confirmed, turn on the propane tank.

Depress the push button ignition and slowly

turn the control panel valve to ON to ignite the

unit.

Tuscany Fire Table—Manual and Installation Instructions Revised …€¦ · manufactured to be used with the Crystal Fire Pit Burner Assembly. This item is not included with the

Documents