IMPLEMENTING HIGH-QUALITY GLOBAL VOICE SOLUTIONS Key factors to be considered by communication service providers while implementing switching & routing infrastructure for enterprise global voice solutions
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Executive summary
In today’s highly competitive and complex telecom landscape, communications service providers (CSPs) are challenged by declining ARPU & margins and must continuously invest in technology and infrastructure to remain competitive. With churn rate and quality demands of customers on the rise,
CSPs must focus greatly on retaining current customers and selling new products and services at higher quality while reducing costs.
One of the main revenue streams of the CSPs is their global voice solution for large enterprises and international contact centers that generate huge outbound and inbound voice traffic to and from various global locations. The success and growth of enterprise voice business is largely dependent on
the quality metrics (ASR and ACD) of the CSP’s global voice solution.
This insight elaborates some of the key factors that CSPs should consider while deploying the switching & routing infrastructure to ensure high quality global voice services – moving ASR (answer-seizure ratio) and ACD (average call
duration) above the industry benchmark.
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Typical challenges faced by CSPs while launching enterprise global voice service
While a CSP might have a strong switching & routing infrastructure, they still face some of the critical challenges listed below when it comes to launching global voice solutions especially for large enterprises.
Handling unpredictable traffic bursts from high
throughput call campaigns is a
challenge for even experienced CSPs.
Limitations in doing protocol stack-level software changes on the switching & routing infra with agility – much required for improving the quality metrics.
Limitations in any-to-any protocol interworking required by enterprises (e.g., ISDN PRI to SS7 ISUP, SIP to SS7 ISUP etc.)
Providing near-real-time quality metrics reporting for enterprises.
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Required major tunings in the infrastructure to enable enterprise global voice service launch 1/2
Support for ISDN PRI and SIP trunks to enable direct
connectivity with enterprise’s TDM/IP PABX and SIP/SS7 for
interconnection with international carriers
Integrated Advance Routing Engine: To support enterprise-wide routing requirements like QoS-based, ASR-based, policy-
based, SLA-based, and percentage-based routing
algorithms
Upgraded to the right version that supports
maximum QoS (quality of service) parameters
Support for high BHCA (busy hour call attempts) and unpredictable traffic bursts from enterprises
(e.g., during campaigns)
Tuning Core Voice Switch
Tuning CDR Mediation Server
Customized to process and categorize enterprise-wide CDRs in near-real-time and
the capability to feed it into the enterprise care
portals
Custom adaptors to provide feeds to CSP
billing platform, customer’s
billing/reconciliation systems, and revenue
assurance systems
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Required major tunings in the Infrastructure to enable enterprise global voice service launch 2/2
Monitor real-time quality metrics, trend analysis
Detailed CDR analysis and bill analysis
Raise and track trouble tickets
Configure routes with priorities based on destinations, time period,
business need, and promotions from CSPs (e.g., choose premium route for
to Canada, standard VoIP route for Mexico for next 3 days etc.)
Enterprise Admin Console with Total Control
Business Intelligence (BI) Dashboard
Custom tool for the CSP’s business team to have a high level business view of all
the enterprise customers on the platform: This tool should be fine-tuned
to provide insightful information to enable promotions for upsell and cross-
sell, churn prevention, QoS improvement, customer experience
enhancement, etc.
Top-10 enterprise customers by revenue
/traffic/destination-wise
Top-10 route/supplier choices
Churn propensity report and trend analysis
Enterprise-wide quality metrics
report
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Key factors to be considered for improving the quality metrics – technical deep dive!
Handling SEQC
(switching equipment congestion)
Rule based echo
cancellation
Support early ACM (address
complete message)
Capability to customize/increas
e network timers
Infra with no single point
of failure (SPOF)
Recommended customization features on the switching platform for improving quality metrics - ASR (answer-seizure ratio), ACD (answer call duration) and NEP (network efficiency ratio).
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Key factors to be considered for improving the quality metrics – technical deep dive! 1/2
Handling SEQC (Switching Equipment Congestion)
Release Message
In a typical deployment scenario, the far-end switch(es) send ISUP switching equipment congestion messages (level-1, level-2 or level-3 warnings) to the CSPs switch depending on its load. By default the CSPs switch would release the call on receiving congestion message. However, if CSP’s switch supports custom SEQC handling
functionality, it can be configured to take appropriate action based on the business need (i.e., to release the call or re-route to alternate route or re-route to same route until level-3 congestion message comes).This procedure can increase the ASR.
Echo Cancellation
On the international voice path, echo is a common issue that affects the quality metrics. Switching Platform software should be customized to support enabling or disabling echo cancellers based on various options: a) Specific routes or destinations; b) Enterprise customer category (standard/premium SLA); c) Circuit ratio (e.g 1 EC
per 16 voice circuits)
Support Early ACM (Address Complete Message)
Enterprise PABX, after sending the SETUP message would wait for a limited time (as per default timer) and if the timer expires, would release the call even before the CALL PROGRESS message comes from the CSP’s switch. This might happen when the destination switch is still processing the call (maybe querying the SCP for balance check) which typically involve four messages and might take a bit longer. To mitigate this issue, the CSP’s switch should support sending ISUP “Early ACM” (called party
status = no indication) to the enterprise switch or PABX immediately upon receiving the SETUP message. This should be a configurable option that can be enabled based on need.
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Key factors to be considered for improving the Quality Metrics – Technical Deep Dive! 2/2
Capability to customize/ increase Network Timers
Network Timer
T7: awaiting address complete (ACM) timer (network protection
timer)
T7 is started in the CSP’s switch when an IAM (initial address
message) is sent, and is canceled when the response message
(ACM) is received from the far-end switch.
When response is not received within timer limit, CSP’s switch
releases the circuit with timer expiry cause.
Potential reasons for delay
Delays might incur at the far-end switch for
various reasons like –
- interrogating the Location registers while
setting up the mobile call
- Paging the mobile subscriber
- Processing delays at MSC, GMSS
- Satellite hops etc..
Solution
Check the current T7 configuration and
increase the timer within the ETSI standards
Other Timers to watch out
T8: awaiting continuity timer. In Inbound call scenario, T8 timer is started in the CSP’s switch when an IAM is received with the continuity indicator bit set. If continuity
message is not received from the far-end switch within the configured time-limit, T8 expires, CSP’s switch sends RELEASE to the originating node.
T9: awaiting answer timer. In outbound call scenario, T9 is started in CSP’s switch when an ACM is received from far-end , and is canceled when an ANM(answer) is received from
far-end switch. It is recommended to keep T9 at optimum level to prevent circuits from being tied up for an excessive period of time when the destination does not answer.
No single point of failure
All elements within the switching & routing infrastructure should be built with no single point of failure. Every element should have dual power supply, dual processors,
dual line cards etc. Additionally a complete disaster recovery (DR) strategy is also recommended to achieve five nines availability and business continuity.
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Benefits for CSPs
Implementing the strategies discussed in this insight would
enable a CSP to offer global voice services to enterprises
exceeding the industry benchmarks on quality metrics.
Answer-seizure ratio (ASR) and average call duration (ACD)
could be improved by 10 to 25% which in turn would help
enterprises do business more efficiently and grow revenues.
Differentiated service offerings
with higher quality
Improve customer loyalty,
increase service uptake, remain
competitive
Maximize revenue!
Confidential & Restricted Copyright © 2017 Prodapt Solutions. All Rights Reserved.
Credits
• John Kingsly, Associate Director – Insights & Presales
Chennai
Johannesburg
New York
Dallas Tualatin
Amsterdam
London
THANK YOU!
Prodapt Solutions Pvt. Ltd.
INDIA
Chennai: 1. Prince Infocity II, OMR Ph: +91 44 4903 3000
2. “Chennai One” SEZ, Thoraipakkam Ph: +91 44 4230 2300
SOUTH AFRICA USA
Prodapt North America Tualatin: 7565 SW Mohawk St., Ph: +1 503 636 3737
Dallas: 222 W. Las Colinas Blvd., Irving Ph: +1 972 201 9009
New York: 1 Bridge Street, Irvington Ph: +1 646 403 8158
Prodapt SA (Pty) Ltd. Johannesburg: No. 3, 3rd Avenue, Rivonia Ph: +27 (0) 11 259 4000
THE NETHERLANDS
Prodapt Solutions Europe Amsterdam: Zekeringstraat 17A, 1014 BM Ph: +31 (0) 20 4895711
Prodapt Consulting BV Rijswijk: De Bruyn Kopsstraat 14 Ph: +31 (0) 70 4140722
UK
Prodapt (UK) Limited Reading: Davidson House, The Forbury, Reading RG1 3EU Ph: +44 (0) 11 8900 1068
Bengaluru
Bangalore: “CareerNet Campus” No. 53, Devarabisana Halli, Outer Ring Road