logbook Three forms of construction: 1. Mass construction (small module & large module) 2. Frame construction 3. Tensile construction Terminology PPE: personal protective equipment UB: universal beam PEC: parallel flange channel UC: universal column MDF: medium-density fiberboard Scale: the relation between the actual size of sth and its size on a map, diagram or model that represents it( eg: 1:100 do not show detail 1:5 show any details) Event 1 Event 2
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
logbookThree forms of construction:1. Mass construction (small module & large module)2. Frame construction3. Tensile construction
Scale: the relation between the actual size of sth and its size on a map, diagram or model that represents it( eg: 1:100 do not show detail 1:5 show any details)
Event 1 Event 2
Brick
Force ( gravity)
dead force: wind/ water→force on objectlive force: →force on people
Material 1. Strength: Steel is much stronger material ★in both compression & tension2. Stiffness: some materials are flexible, stretchy, floppy ★Concrete is a very stiff material 3. Shape: mono-dimensional (linear), bi-dimensional (planar) & tridimensional (volumetric, eg: brick, concrete)4. Material behaviors: isotropic & anisotropic ★sometimes material are equally strong in compression or tension pulling apart, pushing together
5. Economy &sustainability
BluestoneBluestone = basalt
Load Paths ★has direction & scale
---Is simply the direction in which each consecutive load will pass through connected member
↑ the apply load have reaction So the all structure is stable★The reaction has equal and opposite to the apply load in order to be stable
ESD (Environmental standard design)★Strategy: ①Thermal mass ② Solar energy
③ water harvesting ④ night air purging
Jointroller joint pin joint fixed joint
★ Three ways to make the structure more stable1. Fixed joint 2. Bracing 3. Shear panel
Concrete1. Cement 2. water 3. aggregate → fine (sand)
Aim: create a building as high as we can and with a door that is enough
large to let a toy dinosaur get in. 1. We measured the height and width of the dinosaur and then made the
substructure into a square with one side open as a door.
2. In order to reinforce the foundation, we made a wall base. At the two sides of the door ,we built two block of stone used as seats and put heavy bricks on the each side to make them steady
4. Then we built the door like a inverted ladder
Week 2
Aim: to create a building as high as possible.
1. In order to make the foundation stable, we built a triangle
shape as the base. We built the triangle by taping the joints \
3. We staggered the bricks to make the wall stable
5. Once we covered the top of the door, we built the other part of the building, and gradually made it high.
together. Then we framed the model upward and vertical to