FIX-BANDA 160 ATTENTION FIX-BANDA should not be uses: Without previous adhesion tests in- situ on the support in question. In applications not described in this technical sheet without previously consulting the Technical Department. As the only waterproofing solution: FIX-BANDA itself does not replace waterproof paint or mortar. It complements them. In plaster or plasterboard walls without previous primer by HIDROPRIMER. Applying it without pressing properly. Self-adhesive waterproof band for the protection of joints and formation of corners exposed to cracking risks. FIELDS OF APPLICATION Pre-sealing in corners to reinforce the waterproofing in these critical points, indoors, outdoors, terraces, balconies, swimming pools,... Band to bridge expansion joints prior to the application of a waterproofing. TECHNICAL CHARACTERISTICS FIX-BANDA is composed of a visco-elastic layer of butyl rubber, coated with a nonwoven of polyester fibers, which allows the deformation of the band in the transverse direction while limiting the deformation in the longitudinal direction. It is compatible with most supports such as terraces, balconies, decks, swimming pools... HOW TO USE Support: All the supports will always be resistant, solid, clean of dust, paint, wax, oil and grease, and will be perfectly set. Fragile or very porous surfaces, TECHNICAL DATA NON-WOVEN FABRIC: • Type of fiber: Polyester • Mass per m2: 97 g/ml • Breaking strength: 45 +10 N BUTYL RUBBER: • Type of butyl: butyl-polyisobutylene • Loss of mass: <1% • Resistance to slippering of butyl at 5ºC: < 3 mm. (ISO 7390) • Resistance to slippering of butyl at 70ºC: < 3 mm. (ISO 7390) • Maximum elongation: >15% BAND SET: • Temperature of application: from +5ºC to +35ºC • Opertating temperature: from -30ºC to +80ºC STORAGE: • In covered, dry and ventilated places: 36 months DELIVERY: • It supplies: Roll of 10 ml. x 80 mm. they must be previously treated with PRI MFIX or with IMPRIMACION SELLADOR S10 and let them dry at least 1 hour. Application of the strip: remove the self- adhesive paper from only one side and stick it by pressing it firmly on the support. lo con fuerza sobre el soporte. Proceed the same with the other side of the band. Ensure that the band does not form air bubbles. Then we will paint it with FIX- TERRATS (roofs) or protect it with HIDRO ELASTIC (terraces, balconies, ...)