FLEXISTORE 1533 BASE INSTRUCTIONS Flat and firm base. Recommended: concrete, tarmac or paving flags. Min. distance from walls/ shrubbery: 1000mm. Min. base size (WxDxH) 1730mm x 3770mm x 50mm. LEVELING THE UNIT Correctly level the constructed unit using the shims (ZCOMPPLAS) provided prior to fixing the unit to the ground. Slide the packing pieces under the corners of the unit base as required until an equal gap has been achieved around the door allowing for its smooth operation and alignment. For maintenance instructions of this product visit www.asgardsss.co.uk Warning: some panels may weigh over 20Kg. Beware of manual handling 6mm Dia. 13mm Spanner 18V x2 SEALANT Posi-Driv Screwdriver It is always recommended to anchor the unit to the ground. Drill through the four holes in the base of the unit using 6mm dia masonry drill to a depth of 70mm. Screw in the anchor fixings. (These have a self cutting thread). If not anchoring the unit, fit the self seal plugs BEFORE BUILDING to seal the fixing holes from underneath. TOOLS REQUIRED Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill, a 13mm socket or spanner. ZSCREW32 x12 ZSILCOL1 x1 ZSCREW61 x295 ZSCREW340 x9 ZCOMPPLZS02 x12 ZCOMPPLAS22-23-24 x6 2x 2mm, 2x 3mm, 2x 5mm LH REAR SIDE PANEL 44160 x1 RH REAR SIDE PANEL 44161 x1 RH EXT. SIDE PANEL 44292 x1 LH EXT. SIDE PANEL 44291 x1 RH BACK PANEL 44159 x1 REAR TOP PANEL 44156 x1 EXTENSION TOP PANEL 44293 x1 FRONT TOP PANEL 44157 x1 LH BACK PANEL 44158 x1 REAR BASE PANEL 44166 x1 FRONT BASE PANEL 44378 x1 EXT. BASE PANEL 44290 x1 FASCIA PANEL 44167 x1 RH FRONT SIDE PNALE 44163 x1 RH FRONT PANEL 44376 x1 DOOR ASSEMBLY 44374 x1 LH FRONT PANEL 44164 x1 LH FRONT SIDE PANEL 44162 x1 Warning: Please keep this key card safe! Refer to if replacement key is required. 00001 YOUR UNIQUE KEY CODE