It is always recommended to anchor the unit in to the ground. Drill through the four holes in the base of the unit using 6mm dia masonry drill to a depth of 70mm. Screw in the anchor fixings. (These have a self cutting thread). If not anchoring the unit, fit the self seal plugs BEFORE BUILDING to block the fixing holes from underneath. Please note the product must be bolted down to comply with LPS1175. TOOLS REQUIRED Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill and a 13mm socket or spanner. CLASSIC ZSCREW32 x4 ZSCREW100 x102 ZSCREW340 x18 13mm Spanner 18V ZCOMPPLZS02 x4 ZCOMPPLAS22-23-24 x6 2x 2mm, 2x 3mm, 2x 5mm TOP PANEL 31735 x1 BASE PANEL 32076 x1 LH SIDE PANEL 31986 x1 FASCIA 32082 x1 TOOL RAIL 32191 x1 RAIN GUARD 32030 x1 LARGE FRONT PANEL 31985 x1 LH DOOR 32253 x1 RH DOOR 32254 x1 LH BACK PANEL 31736 x1 RH SIDE PANEL 31987 x1 FRONT PANEL TRAP PLATE 31960 x1 RH BACK PANEL 31756 x1 BASE INSTRUCTIONS Flat and firm base. Recommended: concrete, tarmac or paving flags. Min. distance from walls/ shrubbery: 1000mm. Min. base size (WxDxH) 2020mm x 960mm x 50mm. LEVELING THE UNIT Correctly level the constructed unit using the shims (ZCOMPPLAS) provided prior to fixing the unit to the ground. Slide the packing pieces under the corners of the unit base as required until an equal gap has been achieved around the door allowing for its smooth operation and alignment. For maintenance instructions of this product visit www.asgardsss.co.uk Warning: some panels may weigh over 20Kg. Beware of manual handling Warning: Please keep this key card safe! Refer to if replacement key is required. x2 00001 YOUR UNIQUE KEY CODE 6mm Dia. Posi-Driv Screwdriver