Drill through the four holes in the base of the unit using 6mm dia masonry drill to a depth of 70mm. Screw in the anchor fixings. (These have a self cutting thread). If not anchoring the unit, fit the self seal plugs BEFORE BUILDING to seal the fixing holes from underneath. Please note product must be bolted down to comply with LPS1175. TOOLS REQUIRED Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill and a 13mm socket spanner. CENTURION PLUS 2 BASE INSTRUCTIONS Flat and firm base. Recommended: concrete, tarmac or paving flags. Min. distance from walls/ shrubbery: 1000mm. Min. base size (WxDxH) 4940mm x 1730mm x 50mm. LEVELING THE UNIT Correctly level the constructed unit using the shims (ZCOMPPLAS) provided prior to fixing the unit to the ground. Slide the packing pieces under the corners of the unit base as required until an equal gap has been achieved around the door allowing for its smooth operation and alignment. Warning: panels weigh over 20Kg Beware of manual handling 6mm Dia. 13mm Spanner 18V For maintenance instructions of this product visit www.asgardsss.co.uk x2 SEALANT LH R. SIDE PANEL 32874 x1 LH EXT. SIDE PNL 32853 x2 F. BASE PNL 32940 x1 R. BASE PNL 32871 x1 EXT BASE PNL 32850 x2 LH DOOR 32943 x1 RH DOOR 32944 x1 FRONT FASCIA 32948 x1 ZSCREW32 x16 ZSILCO1 x3 ZSCREW04 x4 ZSCREW100 x368 ZSCREW340 x24 32670 x24 ZCOMPPLZS02 x16 ZCOMPPLAS22-23-24 x24 8x 2mm, 8x 3mm, 8x 5mm BASE COVER CHANNEL 37364 x3 SIDE COVER CHANNEL 32916 x6 ROOF COVER CHANNEL 32918 x6 RH F. SIDE PNL 32942 x1 RH EXT. SIDE PNL 32854 x2 LH BACK PANEL 32867 x1 RH BACK PANEL 32876 x1 TOP SHROUD 32945 x2 EXT. TOP SHROUD 32996 x2 RH R. SIDE PNL 32875 x1 F. TOP PANEL 32986 x1 R. TOP PANEL 32987 x1 EXT. TOP PANEL 32927 x2 LH F. SIDE PANEL 32941 x1 Warning: Please keep this key card safe! Refer to if replacement key is required. 00001 YOUR UNIQUE KEY CODE ROOF JOINT STRIP 40446 x6