Transcript
DPMP-16
MATERIALS
DPMP-16
LED´S
DPMP-16
RESISTENCE
DPMP-16
WIRES
DPMP-16
PERSONAL WELDING MACHINE
DPMP-16
BARBED WIRE
DPMP-16
SOLDERING PASTE
DPMP-16
BATTERIES
DPMP-16
DPMP-16
MARKERS
CUTTERS
DPMP-16
SWITCH
DPMP-16
OBJECTIVE
To use recycled material “markers” to make wonderful flashlights.
Steps to make a led flashlights
1. Tomar el led y soldamos usando el soldador de estaño un extremo de la resistencia
First take a led and welding using the personal welding machine each one of the resistance's sides.
2. Siguiente soldamos un extremo del cable con el polo positivo de la bateria.
Next Weld One side with the positive battery side.
3. El otro extremo del cable soldamos a un extremo del pulsador, el otro extremo del pulsador soldamos al polo negativo de las pilas
After Weld the other led’s side with a side of the switch with the negative pole of the battery.
4. Cubrimos los cables con cinta adhesiva Also wrap the wires with adhesive tape
5. Perforamos el extremo posterior del marcador para colocar el pulsador
Next hold the marker’s end and push the switch.
6. Colocamos el led dentro de la parte frontal del marcador After put the led inside the marker’s front.
Finally check the led flashlights, holding on the switch
THANK YOU…
DPMP-16
top related