How to make a led

DPMP-16

MATERIALS

DPMP-16

LED´S

DPMP-16

RESISTENCE

DPMP-16

WIRES

DPMP-16

PERSONAL WELDING MACHINE

DPMP-16

BARBED WIRE

DPMP-16

SOLDERING PASTE

DPMP-16

BATTERIES

DPMP-16

DPMP-16

MARKERS

CUTTERS

DPMP-16

SWITCH

DPMP-16

OBJECTIVE

To use recycled material “markers” to make wonderful flashlights.

Steps to make a led flashlights

1. Tomar el led y soldamos usando el soldador de estaño un extremo de la resistencia

First take a led and welding using the personal welding machine each one of the resistance's sides.

2. Siguiente soldamos un extremo del cable con el polo positivo de la bateria.

Next Weld One side with the positive battery side.

3. El otro extremo del cable soldamos a un extremo del pulsador, el otro extremo del pulsador soldamos al polo negativo de las pilas

After Weld the other led’s side with a side of the switch with the negative pole of the battery.

4. Cubrimos los cables con cinta adhesiva Also wrap the wires with adhesive tape

5. Perforamos el extremo posterior del marcador para colocar el pulsador

Next hold the marker’s end and push the switch.

6. Colocamos el led dentro de la parte frontal del marcador After put the led inside the marker’s front.

Finally check the led flashlights, holding on the switch  

THANK YOU…

DPMP-16