Weighfeeder Application Questionnaire
Preferred Weighfeeder Model:Options:
Open options: Enclosedoptions:
316 SSWW100 WW200 WW300 304 SSPainted mild steelPreferred Construction:
Belt tracking switches
Discharge dust hood Bottom covers
Skirtboard coversSkirtboard covers
Dust tight seals
Dust extraction port
Plugged discharge chute switch
Drag chain clean out conveyor
Safety pull cord switches
Shear curtain Belt cleaning brush
Secondary speed sensor Start, stop, speed, controller
Gravity tensioned belt tracker (WW100/WW300)
Remote totalizer
Installation Power available for motor: volts Hz(indicate all that apply)
4 ... 20 mA AB Remote I/O
RS-232 / RS-485 ModbusDeviceNet
PROFIBUS DP SIMATIC S7 PLCRelays (#):
Inputs required: Outputs required: Communications:4 ... 20 mA PID PID
Weighfeeder
Space limitations:Construction:
Requested belt width:Quantity required: Access side looking in direction of belt travel:
length: width:
Inlet dimensions: L × W: mm/inch Centerline length: mm/inchinlet to discharge
height: mm/inch mm/inch
left rightenclosedopen
Hopper size:
Feed rate:
Accuracy required: Hazardous classification at scale location:
Condition of operating environment:
Ratio controlled blendingBatch Control
ft³/m³
t/hr, kg/hr, lb/hr, LTPH, or STPH
Duty cycle: Material free fall height onto belt:hours per day
min.
%+/-
max. nominal
Feed type:
Sketch attached(Supply sketch where possible)
Load, speed, rate, and totalApplication:
Pre-feed
OtherScrew Bin, hopper, or siloVibratory pan
NormalWash down CorrosiveSanitary
BeltRotary valve
Continuous conveying Discontinuous conveying
sticky powder corrosive fluidizeshighly abrasive
Kg/m³ or lb/cu. ft. or t/m³
degrees degrees
Bulk density:
Temperature:
Moisture content:
Angle of repose:
Material characteristics:Surcharge angle:
Material
mm/inch/meshParticle size:Material being measured:
%
ºC/ºF
Date:
Notes on the Application:
Prepared By:
E-mail:
State/Province:
City: Country:
Address:
Company:
Contact:
Customer information
Zip/Postal Code:
Phone: ( ) Fax: ( )
www.siemens.com/processautomation© Siemens Milltronics Process Instruments Form# 2-773R3
