GRUNDFOS DATA BOOKLET
SP95-18N Rp5 8"3X380-415/50 SD 92kW Grundfos pump 19516918
Thank you for your interest in our products. Please contact us for more information, or visit our website
https://www.lenntech.com/grundfos/SPFAM/19516918/SP-95-18N.html
[email protected]. +31 152 610 900 fax. +31 152 616 289
BE > THINK > INNOVATE
Printed from Grundfos Product Centre [2018.06.003]
Position Qty. Description1 SP 95-18N
Product No.: On request
Submersible borehole pump, suitable for pumping clean water. Can be installed vertically orhorizontally. All steel components are made in stainless steel, EN 1.4401 (AISI 316), that ensures highcorrosive resistance.The motor is fitted with the Grundfos Tempcon sensor that, by use of powerline communicationtogether with a MP204 control panel, enables temperature monitoring.The motor is for star-delta starting (Y/D).
Further product detailsThe pump is suitable for applications similar to the following:
- raw-water supply- irrigation- groundwater lowering- pressure boosting- fountain applications- mining applications- off-shore applications.
PumpAll pump surfaces that are in contact with pumped liquids are made in stainless steel which makesthem corrosion- and wear-resistant. The corrosion diagram below shows the capabilities of the pumpand motor in relation to the temperature in Celsius (y-axis) and the concentration of chloride in ppm(x-axis).
The elastomer parts in the pump are made of NBR (Nitrile-Butadiene Rubber) which ensures goodwear resistance and long service intervals.In case the pump is used for pumping water with high content of hydrocarbons or solvents, Grundfosoffers FKM rubber parts (Fluorocarbon) which are oil and temperature-resistant up to 90 °C.The pump is built with octagonal bearings with sand flush channels that minimise wear. As wear of thepump is inevitable, the pump design allows for easy replacement of all internal wear parts (bearings,impeller, wear rings and seal rings) to maintain high performance and a long lifetime.The suction interconnector is fitted with a strainer to prevent large particles from entering the pump. Thesuction interconnector is designed to comply with NEMA standards for motor mounting/dimensions.
MotorThe motor is fitted with the Grundfos Tempcon temperature sensor device that includes a NTC-resistorwhich senses the temperature. The resistor is built-in close to the winding. The temperature isconverted into a high-frequency signal which is sent via the submersible drop cable and which can beconverted into a temperature reading by means of Grundfos MP204.The MP204 is an electronic motor protection device that also monitors the supply network quality toprotect the submersible motor against supply network disturbances.
1/10
Printed from Grundfos Product Centre [2018.06.003]
Liquid:Pumped liquid: WaterMaximum liquid temperature: 40 °CMax liquid t at 0.15 m/sec: 30 °CLiquid temperature during operation: 20 °CDensity: 998.2 kg/m³
Technical:Rated flow: 95 m³/hRated head: 219 mCurve tolerance: ISO9906:2012 3B
Materials:Pump: Stainless steel
EN 1.4401AISI 316
Impeller: Stainless steelEN 1.4401AISI 316
Motor: Stainless steelDIN W.-Nr. 1.4408/1.4571AISI 316
Installation:Pump outlet: RP5Motor diameter: 8 inch
Electrical data:Motor type: FRANKLINRated power - P2: 93 kWPower (P2) required by pump: 93 kWMains frequency: 50 HzRated voltage: 3 x 380-400-415 VRated current: 188-187-188 ACos phi - power factor: 0.86-0.83-0.80Rated speed: 2920-2930-2930 rpmStart. method: star/deltaEnclosure class (IEC 34-5): IP68Insulation class (IEC 85): FBuilt-in temp. transmitter: yes
Others:Minimum efficiency index, MEI ≥: -.--ErP status: EuP Standalone/Prod.Net weight: 400 kgGross weight: 497 kgShipping volume: 0.785 m³
2/10
Printed from Grundfos Product Centre [2018.06.003]
On request SP 95-18N 50 HzH
[m]
0
50
100
150
200
250
300
350
400
Q [m³/h]0 10 20 30 40 50 60 70 80 90 100 110 120
eta[%]
0
20
40
60
80
100
SP 95-18N, 3*400 V, 50Hz
P2[kW]
0
10
20
30
40
50
60
70
80
NPSH[m]
0
2
4
6
8
10
12
14
16
3/10
Printed from Grundfos Product Centre [2018.06.003]
H[m]
0
50
100
150
200
250
300
350
400
Q [m³/h]0 20 40 60 80 100
eta[%]
0
20
40
60
80
100
SP 95-18N, 3*400 V, 50Hz
P2[kW]
0
10
20
30
40
50
60
70
NPSH[m]
0
2
4
6
8
10
12
14
RP5
4718
195.6
1748
2970
205 GN
M
L1 L2 L3 PE
U1 V1 W1 PE
V2U2W2
3M
L1 L2 L3 PE
U1 V1 W1 PE
V2U2W2
3
U1
W2W1
V2V1
U2
DOLY
Description ValueGeneral information:Product name: SP 95-18NProduct No: On requestEAN number: On requestTechnical:Rated flow: 95 m³/hRated head: 219 mStages: 18Impeller reduc.: NONECurve tolerance: ISO9906:2012 3BModel: BValve: YESMaterials:Pump: Stainless steel
EN 1.4401AISI 316
Impeller: Stainless steelEN 1.4401AISI 316
Motor: Stainless steelDIN W.-Nr. 1.4408/1.4571AISI 316
Installation:Pump outlet: RP5Motor diameter: 8 inchLiquid:Pumped liquid: WaterMaximum liquid temperature: 40 °CMax liquid t at 0.15 m/sec: 30 °CLiquid temperature during operation: 20 °CDensity: 998.2 kg/m³Electrical data:Motor type: FRANKLINApplic. motor: GRUNDFOSRated power - P2: 93 kWPower (P2) required by pump: 93 kWMains frequency: 50 HzRated voltage: 3 x 380-400-415 VRated current: 188-187-188 ACos phi - power factor: 0.86-0.83-0.80Rated speed: 2920-2930-2930 rpmStart. method: star/deltaEnclosure class (IEC 34-5): IP68Insulation class (IEC 85): FBuilt-in temp. transmitter: yesMotor No: 82693726Others:Minimum efficiency index, MEI ≥: -.--ErP status: EuP Standalone/Prod.Net weight: 400 kgGross weight: 497 kgShipping volume: 0.785 m³
RP5
195.6
205GN
4/10
Printed from Grundfos Product Centre [2018.06.003]
On request SP 95-18N 50 Hz
Note! All units are in [mm] unless others are stated.Disclaimer: This simplified dimensional drawing does not show all details.
RP5
4718
195.6
1748
2970
205 GN
5/10
Printed from Grundfos Product Centre [2018.06.003]
Exploded view
301a
219
92
7
7a
77
301a
92
11
9
51
100
49
105
45
215a
215
18
217215a
534a534
531531a
28
17
251d
251a
6
11b
66a
67
530530a
6/10
Printed from Grundfos Product Centre [2018.06.003]
Sectional drawing (TM058200 for TPE2,TPE3)
4
2 13
5
TM058200
7/10
Printed from Grundfos Product Centre [2018.06.003]
Exploded view ( TM057026 for MGE model H/I )
251d
251b
290
287277a
286
277
273a
273
268268a289a289
288b288288a
251a
252b
156c
159d
156b
156d188
275a
153
154
158
178
185
192
191
159e
156c 156
151152
266
187
291
293
252a
172
150
287a
502
273b
157
8/10
Printed from Grundfos Product Centre [2018.06.003]
Parts list SP 95-18N, Product No. On requestValid from 1.9.1999 (9935)
Pos Description Annotation Données de classification Référence Quantité UnitéMotor 1 pcs
- Shaft,cableg,strap 1 pcs- 16 Shaft cpl. 1- Coupling cpl. 1
WasherCoupling
32 O-ring- 17 Strap cpl. Length (mm): 2585 4
Thread: M16Threaded bush 1Lug 1
- 18 Cable guard cpl. 1Holder for cable guard 4Holder for cable guard 2Rail for cable guard 1
1 Valve casing cpl. 1 pcs- 2 Valve cup 1 pcs
Valve cup 1Shaft 1
3 Valve seat 1 pcs3a Retainer for valve seat 1 pcs3b Retainer for valve seat 1 pcs
- 4 Chamber cpl. 1 pcsChamber 1Bearing retainer 1Guide vane 9Cone 1Guide cup 1Guide cup 1
6b Bearing 18b Stop ring 110 Chamber, bottom 17 Seal ring 1 pcs8a Washer 1 pcs
- 9 Chamber cpl. 17 pcs7 Seal ring 18 Bearing 113 Impeller cpl. 17 pcs13 Impeller cpl. 1 pcs14 Suction interconnector 1 pcs15 Strainer 1 pcs
- 18 Cable guard cpl. 1 pcsHolder for cable guard 4Holder for cable guard 2Rail for cable guard 1
18b Screw Length (mm): 6 4 pcsThread: M5
19 Nut 4 pcs19 Nut 4 pcs22 Hex head bolt Length (mm): 60 4 pcs
Thread: M1623 Rubber guard 2 pcs28 Lock 1 pcs39 Helical compression spring 1 pcs
- 70 Valve guide 1 pcsPipe 1Valve guide 1Valve guide 1Valve guide 1
9/10
Printed from Grundfos Product Centre [2018.06.003]
Pos Description Annotation Données de classification Référence Quantité UnitéCone 1
71 Washer 4 pcs77a Cross recess Pan head screw 4 pcs78 Nameplate 2 pcs78a Rivet 2 pcs106 Discharge pipe 1 pcs107 O-ring Diameter: 134.5 1 pcs
Material type: NBRThickness: 3
10/10
Disclaimer: The information about the Grundfos pump in this document may be outdated. Data may be subject to alterations without further notice. Please contact us to verify the data above is still accurate/up-to-date.
All information is copyright Grundfos.
[email protected]://www.lenntech.comtel. +31 152 610 900 fax. +31 152 616 289