XGAZER OPTICS POINT VIEW RED DOT SIGHT WITH LASER.
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
XGAZEROPTICS
POINT VIEWRED DOT
SIGHTWITH LASER.
XGAZER POINT VIEW RED DOT
2
Turn the battery cap counter-clockwise to remove.
Insert a CR123 battery with positive + endtoward the cap.
Tighten the cap by hand only.
Installing The Battery
Loosen the mounting bolt.
Install the sight to the weapon rail by tighteningthe mounting bolt using a flat screw driver.be sure the bolt is positioned in a rail slot for proper fit.
To Avoid over tightening,tighten the screw until you meet light resistance,and then tighten another 1/4 turn.
Mounting The Sight
XGAZER POINT VIEW RED DOT
3
Operation Red Dot Sight Operation:
Press the main On/O� Button to turn on the unit. Adjust the brightness of the red dot using the red dot brightness adjustment button.
To turn o� the sight, hold the on/o� button for 3 seconds. After use, remember to turn the unit o� again to conserve battery life.
Laser Operation:
After turning on the unit using the main on/o� button, press the laser on/o� button to activate the laser.
ZeroingPlease Note. you must zero the red dot and the laser separately. its easiest to zero the red dot sight first, then the laser.
Red Dot Sight zeroing:
Remove windage and elevation caps.
Set up a target at 25 yards, and fire 3 shots.
Find the center of your points of impact and adjust the windage and elevation accordingly. at 25 yds, each click of adjustment will move the point of impact by roughly 1/4". so if your point of impact is 1" low, you would adjust elevation up by for clicks.
XGAZER POINT VIEW RED DOT
4
Continue steps 1 and 2 until your sight is zeroed. Do not continue to adjust wind-age and elevation mechanisms if you encounter resistance- this can damage the sight.
Turn the sight o�, and verify that your sight is still mounted securely to your weapon. Replace caps.
Laser Zeroing:
After the red dot is sighted in, adjust laser windage and elevation screws until the laser lines up with the red dot Please Note: We recommend sighting the laser indoors or at night so the dot is easier to see.
Before attempting to install or maintain the red dot sight , assure that your weapon is unloaded and
the weapon is safely in the safe position.
Warning!
XGAZER POINT VIEW RED DOT
5
Our warranty:We will repair or replace your Xgazer Optics product in the event it becomes damaged or defective — at no charge to you. If we cannot repair your product, we will replace it with a product in perfect working order of equal or better physi-cal condition,
It doesn't matter how it happened, whose fault it was, or where you purchased it. You can count on the Warranty for all Xgazer Optics products!
Please if you have any questions regarding this red dot sight please contact us at [email protected] we will be glad to help you!
Related Documents
