Vex 1.0 © 2006 Carnegie Mellon Robotics Academy Inc. Test Bed Assembly.

Vex 1.0 © 2006 Carnegie Mellon Robotics Academy Inc.

Test Bed Assembly


How do we teach the concepts?


What purpose does this TEST BED serve?

• Teaches or refreshes electrical concepts

• Applies theoretical concepts

• Prepares the student for the future

• Competition – Motivates Students


Concepts Covered?

• Build a teaching tool capable of showing multiple theoretical principles.

• Experience working with electrical and electronic controls

• Help the instructor and students build a safe, uncluttered teaching tool.


Board Construction


Vex Controller


Vex Limit Switch


Vex Bump Switch


Vex RF Receiver ModuleAntenna and Holder


Vex Crystal and Cable


Main Switch


• Controls flow of current from battery

• Mounted before the fuse panel

• Provides an “Emergency Stop” control in the system

• Schematic Symbol for “Single Pole, Single Throw” switch

Main Switch


Terminal Block


Terminal Block

• Allows multiple connection access.

• Allows use of smaller wire to feed multiple accessories.


Fuse Panel


Fuse Panel

NEGATIVE (-) = BLACK POSITIVE (+) = RED


Circuit Protection


The most common types of circuit protection are fuses and circuit breakers.

Circuit Protection


Parts of a blade type fuse

Why doesn’t it work?

Fuses


Relay 1


Solid-State / Electro-Mechanical Relay

• Spike is a 20 Amp, H-Bridge Relay Module that is small enough to be remotely mounted almost anywhere on your robot. Spike is designed for driving small motors in forward, reverse, or stop (brake). Spike is opto-isolated at the signal input to protect the Robot Controller against motor noise and return currents.


Solid-State / Electro-Mechanical Relay How it Works


Relay 2


Pulse Width Modulation ControlsPWM 1


PWM

• What is pulse width modulation?

• What type of wave is produced?

• What makes the PWM different from a Solid State electro-mechanical relay?


PWM

• PWM’s work on the principle of square waves

• Longer duty cycles increase the amount of time the motor runs

• Result : more speed or braking power


PWM


Pulse Width Modulation ControlsPWM 2


Electron Flow

For our purposes, we will use the conventional theory stating that current flows from negative (-) to positive (+).


• Wires, called conductors, carry the current throughout the circuit

• Proper wire size (gauge) is important and may be determined at least 2 ways– Mathematical Formula– Charts

• Size and capacity is rated by professional organizations like AWG (American Wire Gauge).

Electrical Wiring


How Do I Know What Wire to Use?

• Wires come in different sizes. The maximum current each size can conduct safely is shown.

• Make sure the wire is capable of carrying the current load.• Check what the supply Voltage be.NOTE: When it is critical that voltage reduction is minimal, use a larger diameter wire.


Main Switch


Terminal Block


Relay 1


Relay 2


PWM 1


PWM 2


PWM Control Cables


Relay Control Cable


Test Motors


Batteries

Always make sure the battery is disconnected before working on any part of the circuit or components. Always make sure the battery is disconnected and removed from the testbed when it is not in use. Always store the battery in a secure, dry place.

SAFETY

Vex 1.0 © 2006 Carnegie Mellon Robotics Academy Inc. Test Bed Assembly.

Documents

controller slide

holder slide

red slide

cable slide

fuse panel slide

limit switch slide

bump switch slide

terminal block slide