US DEMO MS FW / Blanket Assessment Blanket Design Concepts Prepared by Paul Fogarty, Siegfried Malang Mo Dagher With contributions from the US MS DEMO.

US DEMO MS FW / Blanket Assessment

Blanket Design Concepts

Prepared by

Paul Fogarty, Siegfried Malang

Mo Dagher

With contributions from the US MS DEMO team

UCLA Feb 24 2004

Outboard Blanket Coolant Concepts – Midplane Cross Sections

Mid Plane section View DC – FLiBe + Be OutBoard Blanket

HeliumFlows

HeliumFlows

3D Model DC – FLiBe + Be Blanket Concept

(typical He Flow Circuit for DC Blanket)

Top View – Close-up of Typical Helium Manifolds

HeliumFlow

HeliumFlow

Side View (Poloidal) DC – FLiBe + Be Cross Section Schematic

Mid Plane section View DC – FLiBe + Pb OutBoard Blanket

3D Model DC – FLiBe + Pb Blanket Concept

Side View (Poloidal) DC – FLiBe + Pb Cross Section Schematic

Plan View (Toroidal) FLiNaBe Midplane Cross Section Schematic

FLINaBe Out23

FLINaBe Out13FLINaBe In

Side View (Poloidal) Self-cooled – FLiNaBe Cross Section Schematic

Design Considerations

• Full Length Module design, more detail work is needed to resolve certain design issues such as:

– Header design at the Top of the module that allows proper flow distribution.– Collector design in the Bottom with facilities for all coolant and breeder Flows

• He Inlet/Oulet for DC concept• Flibe Inlet/Outlet for DC-Be and Pb concept• Pb inlet/outlet for DC-Pb concept• FLiNaBe flow circuit for Self cooled concept

– Module structural support – Fabrication, Assembly and installation issues– Maintenance and replacement issues, accessibility and handling

• Molten Salt Design requirements for Blanket Modules and ancillary systems– Module Pre-Heating during startup, Min. Temp control during operation, Idle

conditions and shut down process.– Molten Salt Drainage from Blanket module during shut down.– Ancillary and piping system design, trace heating, heat exchangers and pre-

heating systems etc…