Cloudfone Thrill 430x Driver InstallationNote: Make sure the PC
is using Windows XP OS.1. Turn on the Thrill 430x by pressing the
power button.2. Connect it to a PC via a working USB Cable. 3. The
PC will detect a new device connected to it.a. If it doesnt, try
changing a USB cable.b. If it still doesnt work, the Thrill 430x
might have problems. Please go to the nearest authorized service
center to get it repaired.4. As soon as the PC detects the new
device connected to it, a series of New Hardware Wizard will
appear. Select Cancel to all the windows.
5. Install the drivers for the Thrill 430x from the device. The
drive will appear with a label cdrom_install.
6. Upon double-clicking the drive, it will open the contents.
Run Setup by double-clicking on it.
7. Follow the Setup instructions.
8. Upon finishing setup installation, the Android Driver will
launch. Follow the instructions as well. 9. Upon finishing
Installation, the series of New Hardware Wizard windows will appear
again. This time follow the installation procedures except for
Android wherein it will still be Cancelled. 10. After installing
all the new hardware detected by the PC, disconnect the Thrill 430x
from the PC.11. Remove the battery of the Thrill 430x.12. Put it
back again after 5 seconds.13. Turn on the Thrill 430x by pressing
the Volume Up, Volume Down and Power Buttons simultaneously. If the
Thrill 430x vibrates, let go of the 3 buttons. If it doesnt,
continue holding the 3 buttons for 5 seconds before letting go.14.
Connect the Thrill 430x to your PC via a USB cable.15. Upon
connecting, it will detect a new hardware again. Follow the
installation procedures. 16. After finishing Installation of the
new hardware, proceed to the Thrill 430x SW Tool folder.17. Install
Python by double-clicking on the Phython file in the Thrill 430x SW
Tool folder. Follow the installation procedures. 18. After
successful installation, the PC is now prepared for using the SW
upgrade tool of Thrill 430x.