Copyright Stamp With Amy K 2020 Hallows Night Magic Halloween Card Instructions for this project: 1. Stamp the sentiment from the Hallows Night Magic stamp set in VersaMark Ink on the 3-7/8” x 4- 1/8” panel of Magic In This Night DSP and then heat embossing it with White Stampin’ Emboss Powder. 2. Adhere the 1” x 3-7/8” panel of Magic In This Night DSP to the right side of the 4” x 5-1/4” panel of Basic Black card stock with Stampin’ Seal. 3. Adhere the 1/2” x 3-7/8” strip of Magic In This Night DSP to the back of the stamped DSP panel with Stampin’ Seal 4. Adhere the stamped DSP panel and additional strip to the Basic Black card stock panel with Stampin’ Seal. 5. Adhere the layered panel to the front of the Basic Black card base with Stampin’ Dimensionals. 6. Cut a bat from the Magic In This Night DSP with the bat die from the Halloween Magic Dies. 7. Adhere the bat with a Stampin’ Dimensional to the card front. 8. Adhere of the Iridescent Pearls next to the sentiment. Link to the original blog post for this project: https://wp.me/p2SFwf-kOh Card stock cuts for this project: • Basic Black – 5-1/2″ x 8-1/2″ card base scored at 4-1/4, 4″ x 5-1/4″ panel • Whisper White – 4″ x 5-1/4″ panel (inside card) • Magic In This Night Designer Series Paper – 3-7/8″ x 4-1/8″ panel, 1/2″x 3-7/8″ strip, 1″ x 3-7/8″ strip, Halloween Magic die cut, 5/8″ x 5-1/4″ strip (inside card) Amy Koenders Email: [email protected] website: https://stampwithamyk.com