The pumpkin painted with acrylic paint. A shaded pumpkin. Dress the pumpkin with a stork, leaves and tendrils. A sanded and sealed pumpkin. . Apply an undercoat to the pumpkin preferably using an emulsion type paint. When painted fill any areas that are not smooth then sand, seal and paint. Apply a coat of Acrylic paint to give solid satin finish. Gently sand the grooves to smooth them using a course sand paper. Seal the pumpkin using watered down PVA or Rosco foam coat. When dry, sand the surface to smooth out the larger imperfections. Glue the two halves of the sphere using UHU Por Styrofoam adhesive. Draw on the segments of the pumpkin, dividing in half, then quarters, then eighths, then sixteenths. Flatten the sphere on the top by applying gentle pressure. Using a craft knife cut grooves into the pumpkin following the drawn lines. Using the acrylic orange darkened with a small amount of black paint to use as shading in the grooves. FOAM SCULPTING HOW TO MAKE A PUMPKIN Using a filler fill the joint. When dry sand and then seal. 4D modelshop The Arches 120 Leman St London E1 8EU t:020 7264 1288 e: [email protected] www.modelshop.co.uk SB91028 500mm polystyrene sphere UHU Por Styrofoam adhesive 40g AP00022 Retractable craft knife TK10039 Sandpaper (60/70 grit) TA10000 Foamcoat 500ml FT03005 plus an orange emulsion/acrylic paint of your choice. PRODUCTS USED
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
The pumpkin paintedwith acrylic paint.
A shaded pumpkin.Dress the pumpkin with a stork, leaves and tendrils.
A sanded and sealedpumpkin..
Apply an undercoat tothe pumpkin preferablyusing an emulsion typepaint.
When painted fill any areas that are not smooth then sand, seal and paint.
Apply a coat of Acrylicpaint to give solid satinfinish.
Gently sand the grooves to smooth them using acourse sand paper.
Seal the pumpkin usingwatered down PVA orRosco foam coat.
When dry, sand thesurface to smooth out the larger imperfections.
Glue the two halves of the sphere using UHUPor Styrofoam adhesive.
Draw on the segments of the pumpkin, dividing inhalf, then quarters, theneighths, then sixteenths.
Flatten the sphere onthe top by applying gentle pressure.
Using a craft knife cutgrooves into the pumpkin following the drawn lines.
Using the acrylic orangedarkened with a small amount of black paint to use as shading in the grooves.
FOAM SCULPTING HOW TO MAKE A PUMPKIN
Using a filler fill the joint. When dry sand and then seal.
4D modelshop The Arches 120 Leman St London E1 8EU t:020 7264 1288 e: [email protected] www.modelshop.co.uk
SB91028 500mm polystyrene sphere UHU Por Styrofoam adhesive 40gAP00022 Retractable craft knifeTK10039 Sandpaper (60/70 grit)TA10000 Foamcoat 500mlFT03005
plus an orange emulsion/acrylic paint of your choice.
PRODUCTS USED
Related Documents
