Would you like to become an expert in Oxy-Fuel cutting and get a certificate to prove it? Our goal is to provide you with the right training so that you become a real expert in this area. This time the training takes place at your premises, via the Internet. Specialists from GCE and IHT deliver the first-hand advice on all Oxy-Fuel cutting challenges. We look forward to your participation. Topics to be covered: - Oxy-Fuel flame cutting - Properties of gases and their handling - Safety and standards - A complete solution for Oxy-Fuel cutting Mechanized Oxy-Fuel Cutting IHT Automation Bahnhofstrasse 63 76532 Baden-Baden www.iht-automation.com GERMANY Pavel Sharavara pavel.sharavara@ iht-automation.com +49 7221 39419-47 GCE Cutting & Welding Technologies [email protected] www.gcegroup.com Renata Nádvorníková renata.nadvornikova@ gcegroup.com +420 724 562 542 Become an Expert in Oxy-Fuel Cutting Training Program Seminar goal: The participants should get in-depth theoretical and practical knowledge about Oxy-Fuel cutting. Especially recommended for: Service, shop floor, sales and marketing personnel Trainer: Bernd Pregger, Kurt Nachbargauer - IHT Automation Martin Roubicek, Manfred Greifzu, Martin Ressl - GCE Group Schedule Session Date Time [CEST] Duration [Minutes] 1 st Introduction May 11 13:00 30 2 nd Basics: Oxy-Fuel-principle, gas, flame, applications Basics: Cutting process-principle, materials, preheating, piercing, cutting May 13 13:00 70 3 rd Process Automation, height control, gas pressure regulation, parameters, slag detection, backfire detection May 20 13:00 60 4 th Equipment: Cutting torch and nozzles, COOLEX ® Equipment: Sensors in the torch, hardware & software May 27 13:00 60 5 th Around: Cleaning, gas supply, safety, Do-Nots June 3 13:00 60 6 th Installation Service, HW-integration, SW-integration, support, service, maintenance, on-line Service Tool June 10 13:00 60 7 th Live: Flame ignition, material preheating, piercing, cutting, beveling Questionnaire, Certificates, Summary June 17 13:00 70 The Seminar will use Microsoft Teams as its support. gcegroup.com April 2020 Page 1 iht-automation.com ONLINE TRAINING NOTE! For great interest in this training, we are opening the second round starting on Monday May 11 at 13:00 and continuing each following Wednesday at 13:00.