www.fanatec.com Quick Guide EN Fanatec ® is a registered trademark of Endor AG Designed and developed by Endor AG in Germany Manufactured by Seligenthaler Straße 16 a - 84034 Landshut - Germany Telephone: +49 (871) 9221-122 Fax: +49 (871) 9221-221 Email: [email protected] Website: www.fanatec.com - www.endor.ag 06/2019 NECESSARY FUNCTIONS ANALOGUE PADDLE MODES WHEEL COMPATIBILITY PACKAGE CONTENTS DATAPORT - C ● To accept the High Torque warning message on a Podium Wheel Base you need to turn the steering wheel 90° and wait until the bar on the wheel base display disappears. To switch the Mode of your Podium Advanced Paddle Module you need to enter the Tuning Menu. This can be accessed us- ing the FanaLab software or a button/display module. For further information about the APM Modes, please read the Quick Guide from the Podium Advanced Paddle Module. You need to use M5 screws with a max. length of 16 mm in order to avoid a collision with the Podium Hub. The FANATEC ® wheel rims come with the correct screws. If your wheel rim is not pre-drilled, you can use the drilling template on the Podi- um Hub product page. The DataPort-C on the bottom of the Podium Hub is to connect future Fanatec peripherals with your wheel base. ATTENTION: It is NOT a USB data port and can’t transfer any data between the PC and any attached device that is not coming from Fanatec ® . ● Podium Hub (A) ● Quick Release Adapter (B) ● 2 mm Allen key (C) ● Quick Guide - English ● Centre Calibration can be done by clicking on ‘Centre Cali- bration’ in the driver. ● Shifter Calibration can be done by clicking on ‘Shifter Cali- bration’ in the driver. ● Switching the Mode on the wheel bases without a dedicated “Mode” button is only possible through the Fanatec driver. ● To adjust the Tuning Menu of your wheel base you need to use the FanaLab software or use a suitable button/display module (sold separately). A B Ø 70 mm Ø 50 mm C