Multiconn Srl PORSCHE PCM3.0 – PCM3.1 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate.

Multiconn SrlMulticonn Srl

PORSCHE PCM3.0 – PCM3.1PORSCHE PCM3.0 – PCM3.1

www.dasdvbt.comwww.dasdvbt.com

Installation and User Manual Installation and User Manual ver.1.0ver.1.0 [to integrate with the user manual of DAS M32/M44][to integrate with the user manual of DAS M32/M44]

Fiber OpticFiber Optic

Multiconn SrlMulticonn Srl 2

2. Disconnect the original Fiber Optical cable (fig.4)(fig.4) from the Head Unit and match it directly to DASDAS®® fiber optic female connector of the harness on equipment (fig.5)(fig.5).

44

44 55

Installation PCM3.0- PCM3.1:Installation PCM3.0- PCM3.1:

PCM3.0 – PCM3.1PCM3.0 – PCM3.1

1. To install the DASDAS®® receiver, refer to the specific user manual;

Warning on the connection of the power supply cableWarning on the connection of the power supply cable::

- RED wire (fig.3) must be RED wire (fig.3) must be DISCONNECTEDDISCONNECTED.. The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activityThe switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity

- YELLOW wire (fig.1)(fig.1) must be connected to the +12V permanent/battery- BLACK wire (fig.2)(fig.2) must be connected to the GND.

Power supply cable 11

22

33

3. Match the two other connectors of DASDAS®® harness (fig.6)(fig.6) respectively inside the original accessory (fig.7)(fig.7) and the other one inside DASDAS®® receiver (fig.8)(fig.8).

4. Connect one of the 3 DASDAS®® Video-OUT (fig.8)(fig.8) trough the adapter cables on equipment (fig.9) and the needed accessory (fig.9) and the needed accessory with white Fakra connector (DCABMQS-RCA in fig.9.1) (DCABMQS-RCA in fig.9.1) with the Video-IN on the Head Unit (fig.10)(fig.10).

Multiconn SrlMulticonn Srl 3

77 77 88

66

55

88

99

88

99.1.1 99

PCM3.0 – PCM3.1PCM3.0 – PCM3.1

Multiconn SrlMulticonn Srl 4

The PCM3.0 - PCM3.1 Head Unit module (fig.10)(fig.10).

1010

99.1.1

PCM3.0 – PCM3.1PCM3.0 – PCM3.1

Video-IN

Insert the 2 female crimped pins of DAS cable (fig.9.1 fig.9.1 DCABMQS-RCA) inside the black 12P housing and then in white Fakra cover. In case these connectors are already available in the unit, just connect the pins in the pin-out position recommended below.

Insert the wire with label ++ in pin 27pin 27 (positive signal).If the pin 27 is already used by rear camera, connect to pin 26

Insert the wire with label -- inside the pin 24pin 24 (negative signal).If the pin 24 is already used by rear camera connect pin 25

Black 12P

White cover

User Manual PCM3.0:User Manual PCM3.0:

Multiconn SrlMulticonn Srl 5

PCM3.0PCM3.0

To enter in DASDAS TV tuner:

1) press SOURCE SOURCE then select TVTV icon on touch screen monitor and touch the screen to view images.2) Or press and hold TUNERTUNER button, until the TV TV icon will appear on touch screen monitor

Previous ChannelPrevious Channel(LEFT arrow on remote control)(LEFT arrow on remote control)

Next ChannelNext Channel(RIGHT arrow on remote control)(RIGHT arrow on remote control)

WARNING:WARNING: For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car and make sure that the format is congruent with the set menu on the DAS.and make sure that the format is congruent with the set menu on the DAS.

User Manual PCM3.1:User Manual PCM3.1:

Multiconn SrlMulticonn Srl 6

PCM3.1PCM3.1

To enter in DASDAS TV tuner:

1) press SOURCE SOURCE then select TVTV icon on touch screen monitor and touch the screen to view images.2) Or press and hold TUNERTUNER button, until the TV TV icon will appear on touch screen monitor

Previous ChannelPrevious Channel(LEFT arrow on remote control)(LEFT arrow on remote control)

Next ChannelNext Channel(RIGHT arrow on remote control)(RIGHT arrow on remote control)

WARNING:WARNING: For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car and make sure that the format is congruent with the set menu on the DAS.and make sure that the format is congruent with the set menu on the DAS.

Multiconn SrlMulticonn Srl 7

Remote Control Functions:Remote Control Functions:

ON-OFFON-OFF

TURNING ON/OFFTURNING ON/OFF

LEFT ARROWLEFT ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

CONFIGURATION MENU/OKCONFIGURATION MENU/OK

FUNCTIONS SET UPFUNCTIONS SET UP

DAS MENUDAS MENUTV/RADIO SELECTION TV/RADIO SELECTION AND SEARCH SYSTEMAND SEARCH SYSTEM

NUMBER KEYPAD NUMBER KEYPAD

FOR CHANNEL PRE-SELECTIONFOR CHANNEL PRE-SELECTION

VOLUME ADJUSTMENTVOLUME ADJUSTMENT

UP ARROWUP ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

TV/AV1/AV2 SELECTIONTV/AV1/AV2 SELECTION

RIGHT ARROWRIGHT ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

DOWN ARROWDOWN ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

PCM3.0 – PCM3.1PCM3.0 – PCM3.1

MULTICONN SrlMULTICONN SrlVia Selvetta, 7 - 21100 Varese – ItalyVia Selvetta, 7 - 21100 Varese – Italy

Tel. +39 0332 280512Tel. +39 0332 280512Fax +39 0332 283048Fax +39 0332 283048www.dasdvbt.comwww.dasdvbt.com