Top Banner
Multiconn Multiconn Srl Srl MERCEDES NTG4 – NTG4.5 MERCEDES NTG4 – NTG4.5 Installation and User Manual Installation and User Manual ver.1.0 ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user manual of DAS M32/M44] Fiber Optic Fiber Optic www.dasdvbt.com www.dasdvbt.com
7

Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

Mar 30, 2015

Download

Documents

Emilie Drage
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Page 1: Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

Multiconn SrlMulticonn Srl

MERCEDES NTG4 – NTG4.5MERCEDES NTG4 – NTG4.5

Installation and User Manual Installation and User Manual ver.1.0ver.1.0 [to integrate with the user manual of DAS M32/M44][to integrate with the user manual of DAS M32/M44]

Fiber OpticFiber Optic

www.dasdvbt.comwww.dasdvbt.com

Page 2: Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

1. To install the DASDAS®® receiver, refer to the specific user manual;

Pay attention on the connection of the power supply cablePay attention on the connection of the power supply cable::

- RED wire (fig.3) must be RED wire (fig.3) must be DISCONNECTEDDISCONNECTED.. The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activityThe switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity

- YELLOW wire (fig.1)(fig.1) must be connected to the +12V permanent/battery- BLACK wire (fig.2)(fig.2) must be connected to the GND.

Multiconn SrlMulticonn Srl 2

Power supply cable

11

22

33

2. Disconnect the original Fiber Optical cable (fig.4)(fig.4) from one of the original multimedia accessories inside the car (DVD, GPS, Amplifier, etc…) and match it directly to DASDAS®® fiber optic female connector of the harness on equipment (fig.5)(fig.5).

44 44 55

Installation:Installation:

MERCEDESMERCEDES

Activate the TV tuner with Diagnostic Mercedes System or through Engineering Menu. If TV tuner does not appear as option to set, DO NOT proceed with installation because the system does not support both the Original or aftermarket tuner. In this case it's possible to install the standard DAS receiver (NOT in fiber optic version) using the auxiliary video IN input and the remote control on equipment to command.

Page 3: Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

3. Match the two other connectors of DASDAS®® harness (fig.6)(fig.6) respectively inside the original accessory (fig.7)(fig.7) and the other one inside DASDAS®® receiver (fig.8)(fig.8).

4. Connect one of the 3 DASDAS®® Video-OUT (fig.8)(fig.8) trough the adapter cables on equipment (fig.9) and the needed accessory (DCAB2FK-RCA (fig.9) and the needed accessory (DCAB2FK-RCA in fig.9.1)in fig.9.1) with the Video-IN on the Head Unit (fig.10) (fig.10) by the dual green Fakra connector.

Multiconn SrlMulticonn Srl 3

77 77 88

66

55

88

99

88

99.1.1 99

MERCEDESMERCEDES

Page 4: Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

Multiconn SrlMulticonn Srl 4

Video-OUT

WARNINGWARNING: if the Head Unit module has not the dual brownbrown fakra fakra connector, the car cannot accept an original or aftermarket TV tuner

The back side of NTG4.5 Head Unit (fig.10)(fig.10).

1010

99.1.1

Video-IN

MERCEDESMERCEDES

Video-IN

Page 5: Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

User Manual:User Manual:

Multiconn SrlMulticonn Srl 5

To enter in DASDAS TV tuner press VIDEOVIDEO, then select TV tunerTV tuner.For the management of DASDAS receiver, use the arrow keys or the numeric keypad or the APS controller (joystick).WARNING:WARNING: For the basic settings such as color, contrast, brightness and format, please refer to the menu of For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car and make sure that the format is congruent with the set menu on the DAS.the car and make sure that the format is congruent with the set menu on the DAS.

MERCEDESMERCEDES

Right rotation = UPon remote control (dropdown menu)

Left rotation = Down on remote control (dropdown menu)

Down Joystick Scroll= OK/Menu

Right Joystick Scroll=Right arrow on remote

Left Joystick Scroll=Left arrow on remote

Comand APS controllerComand APS controller

Previous ChannelPrevious Channel(LEFT)(LEFT)

Next ChannelNext Channel(RIGHT)(RIGHT)

Page 6: Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

Multiconn SrlMulticonn Srl 6

Remote Control Functions:Remote Control Functions:

ON-OFFON-OFF

TURNING ON/OFFTURNING ON/OFF

LEFT ARROWLEFT ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

CONFIGURATION MENU/OKCONFIGURATION MENU/OK

FUNCTIONS SET UPFUNCTIONS SET UP

DAS MENUDAS MENUTV/RADIO SELECTION TV/RADIO SELECTION AND SEARCH SYSTEMAND SEARCH SYSTEM

NUMBER KEYPAD NUMBER KEYPAD

FOR CHANNEL PRE-SELECTIONFOR CHANNEL PRE-SELECTION

VOLUME ADJUSTMENTVOLUME ADJUSTMENT

UP ARROWUP ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

TV/AV1/AV2 SELECTIONTV/AV1/AV2 SELECTION

RIGHT ARROWRIGHT ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

DOWN ARROWDOWN ARROWMENU NAVIGATION - ZAPPING KEYMENU NAVIGATION - ZAPPING KEY

PRESS “CLEAR” TO SWITCH TO EMULATION PRESS “CLEAR” TO SWITCH TO EMULATION MODE DIRECTIONAL BUTTONS ON THE MODE DIRECTIONAL BUTTONS ON THE REMOTE CONTROL (5=OK)REMOTE CONTROL (5=OK)

NUMBERS KEYPAD ARE EQUIVALENT TO NUMBERS KEYPAD ARE EQUIVALENT TO REMOTE CONTROLREMOTE CONTROL

MERCEDESMERCEDES

Page 7: Multiconn Srl MERCEDES NTG4 – NTG4.5 Installation and User Manual ver.1.0 [to integrate with the user manual of DAS M32/M44] [to integrate with the user.

MULTICONN SrlMULTICONN SrlVia Selvetta, 7 - 21100 Varese – ItalyVia Selvetta, 7 - 21100 Varese – Italy

Tel. +39 0332 280512Tel. +39 0332 280512Fax +39 0332 283048Fax +39 0332 283048www.dasdvbt.comwww.dasdvbt.com