MDI/DNC MODE The HAAS Control Series PRESS THREE TIMES TO GET TO THIS PAGE (Continued on next slide) Note: SLIDE LEGEND ACTIONS INSTRUCTIONS KEYS INFORMATION.

MDI/DNC MODE

The HAAS ControlSeries

PRESS

THREE TIMES TO GET TOTHIS PAGE

(Continued onnext slide)

Note:

SLIDE LEGEND

ACTIONS

INSTRUCTIONS

KEYS

INFORMATION

To advance through the presentation

click on your left mouse button

or press <ENTER>.

To exit press <ESC>.

To advance through the presentation

click on your left mouse button

or press <ENTER>.

To exit press <ESC>. OTHER INFORMATION

MDI/DNC MODEThis module is

intended to provide you with a

familiarizationof the MDI/DNC

Mode on the Haas Control

Here is where you find the MDI/DNC Buttons

MDI/DNC Buttons

MDI/DNC:

COOLANT:

ORIENT SPINDLE:

ATC FORWARD:

ATC REVERSE:

MDIManual Data Input

DNCDirect Numerical Control

ATCAutomatic Tool Changer

Pressing the MDI/DNC button on the control the first time will display the Manual Data Input screen. Used to input and execute data without disturbing programs in memory.

The second press turns on Direct Numerical Control. Used to execute a program from external devices.

To enable DNC, Setting 55 must be ON.

MDI/DNC Button: PROGRAM (MDI) O91002 N00000

;

MDI/DNC Button:

Press <MDI DNC>This will bring up the MDI screen that will allow you to write to

“scratch pad memory”and execute the

commands.

If you decide to save this program you can do

so by entering a program number that is

not in use and then Press <ALTER>

NOTE:The MDI screen will go blank , but the program is now in the program list under the number

you entered.

MDI/DNC Button: PROGRAM (DNC) O91002 N00000

MDI/DNC Button:

Press <MDI DNC>a second time.

This will bring up the DNC screen that will

allow you to execute a program directly from an external device.

Setting 55 needs to be ON for DNC to be

activated.

WAITING FOR DNC . . .

DNC RS232

WAITING FOR DAT

Coolant Button: PROGRAM (DNC) O91002 N00000

WAITING FOR DNC . . .

DNC RS232

COOLANT Button:

Press <COOLNT>This will turn on the

coolant in any operation mode.

A second press of the key will turn the coolant

off.

Orient Spindle Button:

PROGRAM (MDI) O91002 N00000

;

ORIENT SPINDLE Button:

Press<ORIENT SPINDLE>

This will rotate the spindle to the tool

change position and lock it into place while in

MDI/DNC mode.

ATC Forward Button: PROGRAM (MDI) O91002 N00000

;

T5

ATC FORWARD Button:

ATCAutomatic Tool Changer

Press<ATC FWD>

This will rotate the tool turret forward to the

next tool in the sequence and put it in

the spindle.

NOTE:If a (Tnn) is defined in the input buffer, the

turret will advance to that tool.

ATC Reverse Button: PROGRAM (MDI) O91002 N00000

;

T5

ATC REVERSE Button:

ATCAutomatic Tool Changer

Press<ATC REV>

This will rotate the tool turret in reverse to the

next tool in the sequence and put it in

the spindle.

NOTE:If a (Tnn) is defined in the input buffer, the

turret will advance to that tool.

Prepared by Haas AutomationTraining DepartmentOxnard, CA 93030