Top Banner
Marker Beacons
13

Marker Beacons

Dec 06, 2015

Download

Documents

Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Page 1: Marker Beacons

Marker Beacons

Page 2: Marker Beacons

What is a Marker Beacon?

A marker beacon is a particular type of VHF radio beacon used in aviation, usually in conjunction with an instrument landing system (ILS), to give pilots a means to determine position along an established route to a destination such as a runway.

Page 3: Marker Beacons

What is a Marker Beacon?

• Provides distance information installed on a fixed distance reference points

• to inform the pilot about the horizontal distance from the runway touchdown zone.

• All beacon types operate at a carrier frequency of 75.0 MHz and operate in such a way that they vertically transmit a cone of radio waves.

• The receiver onboard an aircraft is fixed to 75 Hz and will catch the signal during antenna flyover.

Page 4: Marker Beacons

Little Bit of History

• From the 1930s until the 1950s, markers were used extensively along airways to provide an indication of an aircraft's specific position along the route.

• From the 1960s they have become increasingly limited to ILS approach installations.

Page 5: Marker Beacons

Types of Marker Beacons

OUTER MARKER (OM) Normally identifies the final approach fix (FAF) Situated on the same course/track as the

localizer and the runway center-line Four to seven nautical miles before the runway

threshold. transmits a 400 Hz tone signal on a low-

powered morse code: . . . . . . . . . .

Page 6: Marker Beacons

MIDDLE MARKER (MM) It is normally positioned 0.5 to 0.8 nautical miles

(1 km or 3500ft) before the runway threshold. On glide path at the MM an aircraft will be

approximately 200 feet above the runway. Transmits a frequency of 1300 Hz in the headset. Alerts the pilot that the CAT I missed approach

point morse code: . _ . _ . _ . _ .

Page 7: Marker Beacons

INNER MARKER (IM) Located at the beginning (threshold) of the

runway on some ILS approach systems (usually Category II and III).

Transmits a frequency of 3000 Hz in the headset. 1000 feet from the runway threshold. Having decision heights of less than 200 feet (60

m) AGL. morse code: . . . . . . . . . .

Page 8: Marker Beacons
Page 9: Marker Beacons

Marker Beacon Receiver

Page 10: Marker Beacons

Marker Beacon Receiver

Page 11: Marker Beacons

Marker Beacon Antenna

Page 12: Marker Beacons

Other Markers

BACK COURSE MARKER (BC) normally indicates the ILS back course final

approach fix where approach descent is commenced

Its cockpit audio and visual indications are the same as for an inner marker (IM), but its location on the approach course is very different.

Page 13: Marker Beacons

Other Markers

FAN MARKER The term fan marker refers to the older type

of beacons used mostly for en-route navigation

Often part of a non-precision approach and are identified by a flashing white light and a repeating dot-dash-dot signal.