ECE 335: Electronic Circuits Lecture 5: BJT Amplifiers Faculty of Engineering Faculty of Engineering Faculty of Engineering Faculty of Engineering
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
ECE 335: Electronic Circuits
Lecture 5:
BJT Amplifiers
Faculty of EngineeringFaculty of EngineeringFaculty of EngineeringFaculty of Engineering
Linear Analog Amplifier
Basic Characteristics of an Amplifier
Basic Characteristics of an Amplifier
(cont.)
Basic BJT Amplifier
Graphical Analysis of BJT Amplifiers
Graphical Analysis of BJT Amplifiers
(Cont.)
Analysis of BJT amplifiers
DC Analysis and Equivalent Circuit
AC Analysis and Equivalent Circuit
Small-Signal Hybrid-π Equivalent Circuit
Small-Signal Hybrid-π Equivalent Circuit
(Cont.)
Small-Signal Voltage Gain
Input and Output Resistances
Example: DC Circuit Analysis
Example: DC Circuit Analysis (Cont.)
Example: DC Circuit Analysis (Cont.)
-
Small-Signal Hybrid-π Equivalent
Circuit with Early Effect
Example: Determine BJT Amplifier
Parameters
• Determine the small-signal voltage gain, input resistance,
and output resistance of the BJT amplifier circuit in
previous example with the early effect. Assume that the
early voltage is 50V.
19
Common-Emitter Amplifiers (with Voltage-
Divider Biasing & Coupling Capacitor)
Common-Emitter Amplifiers (with Voltage-
Divider Biasing & Coupling Capacitor)- Cont.
Common-Emitter Amplifiers (with Voltage-Divider
Biasing & Coupling Capacitor & Emitter Resistor)
DC & AC Load Lines
• Dc load line is used to find Q-point
• Ac load line is used to determine
graphically the operation of a BJT amplifier
• Dc and ac load lines are essentially different
since capacitors appear as an open circuit
for a de operation but a short circuit for an
ac operation
DC Load Line
AC Load Line
Maximum Output Symmetrical Swing
Saturation
Cutoff
Example (1): Calculate BJT Circuit
Parameters
• Determine the small-signal voltage gain, input
resistance, and output resistance of the circuit
shown in attached Figure. Assume the transistor
parameters are: β=100, VBE(on) =0.7V, and
VA=100V
31
• In the figure, let β=150,VA=200V, VCC=7.5V, VBE(on)=0.7V,
RC=15KΩ, RB=100kΩ, and VBB=0.92V.
a) Determine the small-signal hybrid- parameters rπ, gm, and r0
b) Find the small-signal voltage gain Av
Example 2
Related Documents
