CNC Repair Procedure: How to Disassemble the Turret Clamp/ Unclamp Piston on a Fuji HM-30 CNC Milling Machine (Alarm 1002 Turret Clamp/ Unclamp Time Over) Posted on May 2, 2011 by pinpoint1 BUILDER: FUJI MODEL: HM-30 CONTROL: FANUC 21iM TITLE: TURRET INDEX TIME OVER ALARM. TURRET NOT FULLY UNCLAMPING. SUMMARY: CORROSION IN THE BORE FOR THE TURRET UNCLAMP PISTON PREVENTED FULL UNCLAMPING. CLAMPING CYLINER NEEDED TO BE REMOVED. ALARMS: 1002 DETAILS: 1. Index turret to station 1 and make sure it’s clamped. If the motor will not rotate the turret, you can look at the tool-driver to make sure you are in the correct location. The friver should be centered on the hole at the turret station at the 9 o’clock position. You can then use the solenoid valve to clamp.
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
CNC Repair Procedure: How to Disassemble the Turret Clamp/ Unclamp Piston on a Fuji HM-30 CNC Milling Machine (Alarm 1002 Turret Clamp/ Unclamp Time Over)Posted on May 2, 2011 by pinpoint1
BUILDER: FUJI
MODEL: HM-30
CONTROL: FANUC 21iM
TITLE: TURRET INDEX TIME OVER ALARM. TURRET NOT FULLY UNCLAMPING.
SUMMARY: CORROSION IN THE BORE FOR THE TURRET UNCLAMP PISTON
PREVENTED FULL UNCLAMPING. CLAMPING CYLINER NEEDED TO BE REMOVED.
ALARMS: 1002
DETAILS:
1. Index turret to station 1 and make sure it’s clamped. If the motor will not rotate the
turret, you can look at the tool-driver to make sure you are in the correct location. The
friver should be centered on the hole at the turret station at the 9 o’clock position. You