Getting Started With Chips Cope

7/29/2019 Getting Started With Chips Cope

1/12

Z:\Home\cse465\Tools\GettingStartedWithChipScope.docPage 1 of 12

Getting Started with Chip Scope

(reference

http://www.xilinx.com/support/documentation/sw_manuals/chipscope_pro_sw_cores_10

_1_ug029.pdf)

This tutorial assumes that you have Verilog code with the ILA and ICON cores

instantiated and have assigned ChipScopeData and ChipScopeTrig0 to useful signals.

1. Run ChipScope Pro Analyzer
http://www.xilinx.com/support/documentation/sw_manuals/chipscope_pro_sw_cores_10_1_ug029.pdfhttp://www.xilinx.com/support/documentation/sw_manuals/chipscope_pro_sw_cores_10_1_ug029.pdfhttp://www.xilinx.com/support/documentation/sw_manuals/chipscope_pro_sw_cores_10_1_ug029.pdfhttp://www.xilinx.com/support/documentation/sw_manuals/chipscope_pro_sw_cores_10_1_ug029.pdfhttp://www.xilinx.com/support/documentation/sw_manuals/chipscope_pro_sw_cores_10_1_ug029.pdf


2/12


2. Select JTAG Chain -> Xilinx Platform USB Cable


3/12


3. Click OK

4. Click OK


4/12


5. Right click on DEV 2 and select Configure


5/12


6. Click on Select New File and browse to .bit file and click OK.

7. Set the Trigger on Match Unit MO to XXXX_X111 to trigger on the 3 LSBs ofthe ChipScopeTrig0.


6/12


8. Collapse the DataPort vector into Busses by selecting a group of signals, rightclick on the signals and select Add to Bus -> New Bus.

9. Right click on the Bus Name and select Rename.


7/12


10.Select the signals again, right click and select Remove From Viewer after the Busis created.

11.When the Waveform window is formatted correctly, click the Run button.


8/12


12.When the trigger occurs the waveform will be displayed.


9/12


Generating ILA and ICON cores

1. Run Project Navigator2. Right click on the project and select New Source3. Select IP (CORE Generator & Architecture Wizard)4. Set the File Name to icon5. Click Next.

6. Select ICON (ChipScope ProIntegrated Controller) v1.03.a in theChipScope Pro folder in the Debug & Verification folder

7. Click Next8. Click Finish


10/12


9. Click Finish10.Right click on the project and select New Source11.Select IP (CORE Generator & Architecture Wizard)12.Set the File Name to ila13.Click Next.


11/12


14.Select ILA (ChipScope ProIntegrated Logic Analyzer) v1.03.a in theChipScope Pro folder in the Debug & Verification folder

15.Click Next16.Click Finish

17.Uncheck Data Same As Trigger and set Data Port Width to 100 to store 512samples of 100 bits when a trigger occurs.

18.Click Next


12/12


19.Set # Match Units to 2 and Match Type to Extended.20.Click Finish

Getting Started With Chips Cope

Documents