FITTING INSTRUCTIONS FOR RYCO CABIN FILTER RCA194P HOLDEN CAPTIVA (CG) SERIES I & SERIES II INSTRUCTION SHEET IS194P GUD Automotive Pty Ltd 29 Taras Ave Altona North Victoria 3025 Australia www.rycofilters.com.au GUD (NZ) Holdings Limited 626A Rosebank Road Avondale Auckland, New Zealand www.ryco.co.nz GUD Automotive - A Division of 1 Filter is located behind glove box. Remove glove box to acces cabin filter housing. A regular size Phillips screw driver and a small flat head screw driver will be required to perform the job. 2 Remove the bottom screws of the glove box as indicated. 3 Once bottom screws are removed proceed to open glove box and remove the top screws as indicated on the image. Then gently pull the glove box out until connectors are seen. Remove the top connector first by gently pulling it. Then tilt forward glove box to reach for rear connector. You may need a small flat head screw driver to release. Once glove box is out of the way it will be very easy to identify cabin air filter housing. 4 Identify cabin air filter housing which will be sitting on top of air blower. Proceed by removing screw on housing lid and remove to acces filter. Remove filter and clean housing of any dirt or leaves. Identify cabin air filter housing which will be sitting on top of air blower. Proceed by removing screw on housing lid and remove to acces filter. Remove filter and clean housing of any dirt or leaves. Replace cabin air filter by inserting it in the right air flow direction as indicated. See filter frame to identify direction in which filter has to be fitted. Refit all previously removed components in reverse order. 5 6
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
FITTING INSTRUCTIONS FOR RYCO CABIN FILTER RCA194PHOLDEN CAPTIVA (CG) SERIES I & SERIES II
INSTRUCTION SHEET IS194P
GUD Automotive Pty Ltd29 Taras Ave Altona NorthVictoria 3025 Australiawww.ryco�lters.com.au
GUD (NZ) Holdings Limited626A Rosebank Road AvondaleAuckland, New Zealandwww.ryco.co.nz
GUD Automotive - A Division of
1Filter is located behind glove box. Remove glove box toacces cabin filter housing.A regular size Phillips screw driver and a small flathead screw driver will be required to perform the job.
2
Remove the bottom screws of the glove box as indicated.
3
Once bottom screws are removed proceed to openglove box and remove the top screws as indicated on theimage. Then gently pull the glove box out untilconnectors are seen.
Remove the top connector first by gently pulling it. Then tiltforward glove box to reach for rear connector. You mayneed a small flat head screw driver to release.
Once glove box is out of the way it will bevery easy to identify cabin air filter housing.
4
Identify cabin air filter housing which will be sitting ontop of air blower. Proceed by removing screw onhousing lid and remove to acces filter.Remove filter and clean housing of any dirt or leaves.
Identify cabin air filter housing which will be sitting ontop of air blower. Proceed by removing screw onhousing lid and remove to acces filter.Remove filter and clean housing of any dirt or leaves.
Replace cabin air filter by inserting it in the right air flowdirection as indicated. See filter frame to identify directionin which filter has to be fitted. Refit all previously removedcomponents in reverse order.
5 6
Related Documents
