Hydraulic pumps Pumps are designed for easy usage at the pressures and volumes that are needed for ETP-HYLOC. All pumps are of a robust design and CE marked. The motorpump is especially designed for use with larger sizes of ETP-HYLOC, size < 150 mm, or when mounting/dismantling is to be made frequently. All pumps are equipped with manometer and hoses (length 3 m). A threaded connection G 1/8 is on each hose which is suitable for direct mounting in ETP-HYLOC. Max. working pressure is 1 500 bar, controlled by a pressure release valve. The Handpump H-11 can also be delivered with a set max. working pressure of 700 or 1 000 bar. When ordering contact us for a configuration. When there is a need for fast and frequent mounting, the pumps can be equipped, as accessories, with special high pressure quick connections. A quick connection consists of one chuck (C), mounted on the pump hose, and one nipple (N), mounted in the pressure connection of ETP-HYLOC. Quick connections Chuck C-03 ETP Part number: 19143 Nipple N-03 ETP Part number: 19142 Quick connection type 03. The chuck, C-03 is pressed onto the nipple, N-03. Note: This type has bigger built-in dimensions and can not be used axially, if the shaft pass all the way through, for sizes ≤ 110 mm of ETP-HYLOC. Hand pump H11 ETP Part number: 19102 • For use with ETP-HYLOC • Delivered in steel box • 2 pressure hoses + 1 return hose (3m) • Incl. 2 L SAE 80 W oil • Including assembly kit A and B. Motor pump A-04 Part number: 19112 • For use with ETP-HYLOC. • Delivered in steel box • 2 pressure hoses + 1 return hose (3m) • Incl. 2 L SAE 80 W oil • Including assembly kit A and B Motor pump A-04 Pneumatically driven. Delivered in a practical steel box. Hand pump H-11 Delivered in a practical steel box. ETP-HYLOC accessories ETP Transmission AB There are the following 2 versions: Quick connection type 02. The chuck, C-02, is screwed onto the nipple, N-02, with an outer ring. Chuck C-02 ETP Part number: 19131 Nipple N-02 ETP Part number: 19121