Environmentally Friendly Fine Machining Process of Wood Taiwan China Wen-Ching Su * Yiren Wang and Huoh-Jong Shiau Good morning! Welcome to Taiwan!

Environmentally Friendly Fine Machining Process of Wood

Environmentally Friendly Fine Machining Process of Wood

Taiwan

China

Wen-Ching Su* Yiren Wang and Huoh-Jong Shiau

Wen-Ching Su* Yiren Wang and Huoh-Jong Shiau

Good morning! Welcome to Taiwan!

Aim of work and methodsAim of work and methods

A self-designed two-step surface planer with oblique angles of 15° and 20° used to machine China-fir, hard maple and red oak.

Apparatus of two-step surface planer

Aim of work and methodsAim of work and methods

The surface quality between one-set and two-set oblique

cutting will be explored.

The surface quality between one-set and two-set oblique

cutting will be explored.

The machined surfaces were compared to

sanding and planning.

The machined surfaces were compared to

sanding and planning.

ObjectObject

ResultsResults

Fig.1 Chip formation

It could produce different chips for the same oblique angle in cutting softwood and

hardwood. China fir Hard maple

ResultsResults

Fig.2 Surface roughness

The peak of roughness profile was near the center line, that is, the latewood did not protrude the

earlywood on the machining surface of surface planer.

sanding surface

planning surface

oblique cutting surface

ResultsResults

Fig.3 SEM observation of machining surface

The surface structure of wood was crushed or torn after planning. The damage surface could removed by the

two-step oblique cutting

A-sanding surface, B-planning surface, C-oblique cutting surface

planning surface

sanding surface

oblique cutting surface

ConclusionsConclusions

The planning surface processed by oblique cut once more could remove the deformation layer of surface to

show the wood structure clearly

Obtain a more fine and smooth surface.Obtain a more fine and smooth surface.