DIY Camera Stabiliser 27.01.16
DIY Camera Stabiliser27.01.16
Essentials>24” PVC pipe
2 T joints
4 elbow joints
2 machine screws and wing fasteners
PVC glue
Hacksaw
Drill
1/4” drill bit
Measuring tape
AssemblyMy dad and I first cut the
PVC pipe to two 1 foot pieces and four 5” pieces. After
sanding the ends, we fitted the joints, without gluing.
Nuts & boltsAfter making sure all the pieces fit together, we drilled the holes in the two T joints - one for the screw on which the camera will be mounted
and one for the (shorter) screw that will fasten the removable handle.
Gluing With all the pieces cut down to size, sanded, wiped clean and drilled, we proceeded to gluing the whole thing together with PVC glue.
Assembly v.2We needed to make sure all
the parts (especially the joints) were completely
aligned, and that one T joint needs to be pointed upwards
and the other outwards.
Final touches + fittingWe up-cycled a rubber bottle cap by attaching it to the T joint on which my camera will be mounted. This would prevent any scratches on the
bottom of my camera, from being spun onto the PVC.
TA-DA!