Detection of Leaks In Offshore Pipelines - MTS: MTS Home Subsea Leak... · • Focus on distributed sensors for offshore leak detection 2. Project Drivers ... • Performance over

Detection of Leaks In Offshore PipelinesShane SiebenalerSouthwest Research Institute

1

Joint Industry Program• Program commenced in early 2013• Focus on distributed sensors for offshore leak detection

2

Project Drivers• Offshore leak detection needs:

• High reliability and sensitivity for small leaks• Continuous detection capability (time and space)• Ability to locate leaks• Performance over wide range of pipeline conditions

• Two candidate technologies identified:• Distributed temperature sensing (DTS)• Distributed acoustic sensing (DAS)

• Commercial technologies exist• Lack of available data for offshore applications

3

Project Overview• Overall scope

• Study the leak behavior (thermal, acoustic) for various leaks• Perform testing of fiber-based systems

• Underlying motivation• Understand main drivers of leak propagation (e.g. fluid properties,

location, etc.)• Evaluate ability of systems to detect leaks (specific applications

may require further work)

• Overall objective• Determine, in controlled environment, if DTS and DAS can detect

small (<0.25”) leaks

4

Project Progression

5

Engage operators as to establish range of each parameter

Characterize acoustic and thermal profiles

Design and fabricate test bed(s)

Conduct large-scale testing of systems

Baseline Conditions• Line size: 0.51-0.76 m (20-30 in)• Water depth: 300 m (984 ft)• Internal pipeline pressure: 3.45-13.79 MPa (500-2,000

psi)• Oil: 20-30 °API• Minimum gas temperature: 278 K (40°F)• Minimum oil temperature: 305 K (90°F)• Nominal water temperature: 277 K (39°F)• Simulated leak size: ≤ 6.35 mm (0.25 in) diameter

6

Characterization Work• Topics:

• Jet-to-plume transition lengths• Water entrainment• Temperature profiles• Plume migration (near-field)• Near-field acoustics

• Approaches:• Analytical modeling• Numerical modeling• Small-scale testing

7

Two CasesLeak Into Water Leak Into Soil

8

Small-Scale Testing

9

Small-Scale Testing – cont’d

10

Small-Scale Testing Cont’d

11

Large-Scale Testing• Seven technology

providers• Three DAS• Four DTS

• Separate test beds for water and soil

• Test objective was event detection

12

Water Testing

13

Water Test Bed

14

Equipment Installation

15

Overall Layout

16

Leak Location/Size Summary• 20”-diameter pipe• 14 different leak ports

• Size ranging from 1/32” to 3/16”• Some directly under cable, most

offset from cable• Three radial positions

17

Cable Installation

18

10-km and 25-km spools used upstream

Example Nitrogen Leak

19

Soil Testing

20

Soil Bed

21

Testing In Soil• Leak sizes from 1/32” to 1/8”• Soil bed “reset” between each run

22

Cable Arrangement

23

10-km spools used upstream

Pipe Section

24

Setup

25

Project Status• Most testing is complete• Results from testing show promise in systems being

applicable to offshore pipelines• Large-scale testing results planned for publishing in 2015

• Looking towards expansion to future topics• Open to new operators joining the JIP• May tackle future projects as one-time activities as opposed to

continuation of single program

26

Future Topics of Interest• Non-orifice leak geometries• Multiphase flow• Inflow• Cable installation

27

Questions?Shane SiebenalerManager, Fluid DynamicsSouthwest Research [email protected]

28