Cyclic behaviour of unreinforced and rib-reinforced moment connections

Journal of Constructional Steel Research 61 (2005) 1–21 www.elsevier.com/locate/jcsr Cyclic behaviour of unreinforced and rib-reinforced moment connections Cheng-Chih Chen ∗ , Shuan-Wei Chen, Ming-Dar Chung, Ming-Chih Lin Department of Civil Engineering, National Chiao Tung University, 1001 Ta Hsueh Road, Hsinchu 30010, Taiwan Received 9 February 2004; accepted 29 June 2004 Abstract This study investigates the cyclic behaviour of the beam-to-column welded moment connections used in steel moment-resisting frames. Two unreinforced welded connections were tested initially to elucidate the behaviour and failure mode. Test results showed that both specimens failed by the brittle fracture of the beam flange, initiated from the root of the weld access hole. Nonlinear finite element analysis was used to identify the causes of the failure. The stress concentration in the weld access hole region has the potential to cause the beam flange to fracture. Analytical results also demonstrated that reinforcing the connection with a single rib can reduce the concentration of stresses at the root of the weld access hole. Further tests of two specimens whose beam flanges were each reinforced by a single rib revealed that the single rib effectively prevents beam flange fracture in the weld access hole region. © 2004 Elsevier Ltd. All rights reserved. Keywords: Welded moment connection; Weld access hole; Flange rib; Plastic rotation ∗ Corresponding address: Department of Civil Engineering, National Chiao Tung University, 1001 Ta Hsueh Road, Hsinchu 30010, Taiwan. Tel.: +886 3 571 2121x54915; fax: +886 3 572 7109. E-mail address: [email protected] (C.-C. Chen). 0143-974X/$ - see front matter © 2004 Elsevier Ltd. All rights reserved. doi:10.1016/j.jcsr.2004.06.005

Cyclic behaviour of unreinforced and rib-reinforced moment connections

Documents

welded moment connection

weld access hole

flange rib

plastic rotation