Connecting devices / trainers in TTS 4.12.1 Select Setup ... · Connecting devices / trainers in TTS 4.12.1 Select Setup - > Device Manager Select -Add Device-

Connecting devices / trainers in TTS 4.12.1

Select Setup - > Device Manager

Select -Add Device-

When you see NO ANT USB STICk connected then that is NOT a problem for i-Flow or Fortius users.

You do not need this. Just press SCAN. The select one by one the Trainer

If you have an i-Genius – Vortex or Bushido trainer, then you need to plug in your USB antenna

Now SELECT the Device (the picture) with your mouse.

Then the button CONNECT will highlight. Now press connect

For the Genius the Steering Calibration will appear. Follow the procedure

After this, connect the other Devices

With the Genius the ALIGNMENT is not needed. If you do this, make sure that the tire is not

connected to the roller.

When everything is connected, the stat buttons will be highlighter

FORTIUS AND FLOW USERS – connecting analogue heartrate belts

You need to follow the same connection process, with your heart rate belt on. It is important that

you are close to your T1932 or T1942 interface so that the analogue signal can be received by the

head unit. Then it will appear in the software and you can connect.

Use also USB2 port. This will not cause any disconnect events.