Component Check RS232 Cable -Supplied MJ10-22-CS35 (USB to Serial converter) -Additional MJ10-22-CS25 (RJ11 to DB9 converter) -Supplied.

Connect to a Controller &

Update the OS

Component Check

RS232 Cable

-Supplied

MJ10-22-CS35 (USB to Serial converter)-Additional

MJ10-22-CS25 (RJ11 to DB9 converter)-Supplied

Check physical connections

• Jumpers are set for RS232 communication

Port 1

• Check part numbers -Serial cable MJ10-22-

CS25 -USB adapter MJ10-22-

CS35

• Serial cable plugged into Port 1 on PLC

USB programming cable

• Some of our units can be programmed through a Mini-USB programming port- (If equipped, IE- V1210/V1040/V570)

• No other hardware is required for USB connection

Note that COM port 1 function is suspended when the USB port is physically connected to the PC.

USB Driver

USB port supports only OS and project download.

• If requested to use Windows Update--do not accept this option; "Skip obtaining driver software from Windows Update".

• Install only the driver provided by VisiLogic.• The USB cable must be disconnected during

the installation.

Driver Check

Check software settings

• Baud rate

- Standard-57600 baud

- Enhanced-115200 baud

• Select “Get OPLC Info” button to check/confirm PLC

• Check Device Manager to ensure -Port has no errors or warnings (PC port is confirmed here)

Check for O/S updates

• Requires connection to internet.

• Updates automatically if required.

Has a new O/S been released?

You will receive one of 2 messages.

-Up to date.

-Updating files

Check & perform an O/S update

Updating an OS

• The System Upgrade Wizard will guide you through the update of the OS

O/S Updating

– A Progress Bar will show you the operations and current steps in progress

Finish Update of O/S

• Successful OS Update

O/S Update Not Required

Thank you !