Service Manual Service Manual THIS IS A MANUAL PRODUCED BY JENSALES INC. WITHOUT THE AUTHORIZATION OF INTERNATIONAL HARVESTER OR IT’S SUCCESSORS. INTERNATIONAL HARVESTER AND IT’S SUCCESSORS ARE NOT RESPONSIBLE FOR THE QUALITY OR ACCURACY OF THIS MANUAL. TRADE MARKS AND TRADE NAMES CONTAINED AND USED HEREIN ARE THOSE OF OTHERS, AND ARE USED HERE IN A DESCRIPTIVE SENSE TO REFER TO THE PRODUCTS OF OTHERS. C & G Cream Seperators IH-S-CREAM SEP
7
Embed
C & G Cream Seperators...Milk handling unit--G models Milk handling unit--F models Motor-drive unit--all models Principles of operation . . . . ~ ... The International Harvester Cream
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Serv
ice
Man
ual
Service Manual
THIS IS A MANUAL PRODUCED BY JENSALES INC. WITHOUT THE AUTHORIZATION OF INTERNATIONAL HARVESTER OR IT’S SUCCESSORS. INTERNATIONAL HARVESTER AND IT’S SUCCESSORS
ARE NOT RESPONSIBLE FOR THE QUALITY OR ACCURACY OF THIS MANUAL.
TRADE MARKS AND TRADE NAMES CONTAINED AND USED HEREIN ARE THOSE OF OTHERS, AND ARE USED HERE IN A DESCRIPTIVE SENSE TO REFER TO THE PRODUCTS OF OTHERS.
Supply can support tube--Model F. Supply tube lifting lever--Model F.
Inspection and repair. . . . . . . . . . Assembly of tinware . . . . . . . . . . Adjusting supply can spider--Model F
Metering valve assembly service Model G separators. . . . . . . . . . . Model F separators. . . . . . . . . . .
Servicing the bowl assembly - all models Disassembly. . . . . . . . Inspection and repair. . . . Assembly and adjustment. .
Motor assembly ~ervice Motor-drive unit--model G. Motor-drive unit--model F. Motor service without removal--all models Motor removal and service Mercury switch . . . . . . . . . Governor ........... . Motor unit installation . . . . .
Refinishing the separator body . Trouble shooting chart . . . . . .
Illust. 7--Cross-section of bowl flushing at separating speed, 10,000 rpm. The bowl ring is expanded and the washing vents are sealed.
Washing
The operator should carefully follow the steps outlined in the Operator's Manual. Because the washing water is released into the bowl at 10 times the volume of the normal milk flow, the sediment is washed off with considerable force.
After the motor is switched off and the bowl speed falls to around 7,000 rpm, the bowl ring contracts, allowing the water and sediment to escape through the washing vents. Then the operator should switch the power on again so that the water will flow through the area exposed by the contracted bowl ring. Baffles on the collectors assist in thorough washing of all surfaces. See I1lust. 8.
12
Illust. 8--Cross-section of washing action with bowl turning at .7,000 rpm or less. The bowl ring is contracted and the washing slots are open. The bowl is washed inside and out.
Sterilizing
After washing, the operator should sterilize the bowl and collectors, using eight quarts of hot water at at least 1800 F, as outlined in the Operator's Manual.
He should pas s about one -third of the hot water through the machine with the bowl turning at full speed. He should put the balance of the water through after the speed has been reduced and the bowl ring has contracted. In this way, both the inside and outside of the bowl are sterilized along with the collectors.
After the water stops flowing from the collectors, he should turn on the motor again and run the separator for two or three minutes. The heat from sterilization and the high speed rotation will thoroughly dry all the parts.