Synopsys on the major project “ANTENNA POSITIONING SYSTEM” In this project we use one small antenna , which is rotated by the PC in clock wise and anti clock wise direction. One sensor is connected on the antenna to get a the signal from the transmitter. When antenna sensor receive a signal then pc stop the antenna and at that time pc show the stop direction. PC use a C++ base software, Antenna is connected on the stepper motor. Stepper motor control by pc parallel port. Parallel port provide a output to the stepper motor. As the sensor get a signal, this signal is further connected to the pc parallel port to provide a input
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
Synopsys on the major project
“ANTENNA POSITIONING SYSTEM”
In this project we use one small antenna , which is rotated by the PC in clock wise and anti clock wise
direction. One sensor is connected on the antenna to get a the signal from the transmitter. When
antenna sensor receive a signal then pc stop the antenna and at that time pc show the stop direction. PC
use a C++ base software, Antenna is connected on the stepper motor. Stepper motor control by pc
parallel port. Parallel port provide a output to the stepper motor. As the sensor get a signal, this signal is
further connected to the pc parallel port to provide a input
Component required
• Motor (Stepper)
• LEDs
• ADC
• Optocoupler
• Buzzer
• Relay
• IR Sensor
• Parallel port connector
• Power Supply Circuit
• Resistances
• Capacitors
• Diodes
• Transistors (PNP, NPN)
• Pull-up register
• PCB
• Solder
• wire
Related Documents
