ttp://iaeme.com/Home/journal/IJCIET [email protected] h 354 International Journal of Civil Engineering and Technology (IJCIET) Volume 7, Issue 3, May June 6, pp. 354 , Article ID: IJCIET_07_ – 201 –364 03_036 Available online at ttp://iaeme.com/Home/issue/IJCIET?Volume=7&Issue=3 h Journal Impact Factor (2016): 9.7820 (Calculated by GISI) www.jifactor.com ISSN Print: 0976-6308 and ISSN Online: 0976-6316 © IAEME Publication ANALYSIS AND COMPARATIVE STUDY OF COMPOSITE BRIDGE GIRDERS Patil M.B PG Student, SKN Sinhgad College of Engineering, Korti, Pandharpur, Maharastra, India Y.P.Pawar, Kadam, D. S.S. D.Mohite, S.V. Lale, C.M. Deshmukh Assistant Professor, Department of Civil Engineering, SKN Sinhgad College of Engineering, Korti, Pandharpur, India C.P. Pise Associate Professor & HOD, Department Civil Engineering Department, SKN Sinhgad College of Engineering, Korti, Pandharpur, Maharastra, India ABSTRACT The composite bridge gives the maximum strength in comparison to other bridges. The design and analysis of various girders for steel and concrete by using various software, that paper for composite bridge calculate the in bending moment for T girder and finding which is more effective. The forts ef will make to carry out to check the analysis of bridge by using SAP 2000 software. To determine the static analysis of T girder by using manual method as well as software. The results obtained from the software in structural analysis are compare the results obtained from manual calculations. Key words : T Girder, IRC Loading, SAP2000 Software AA Cite this Article: Patil M.B, Y.P.Pawar, S.S.Kadam, D.D.Mohite, S.V. Lale, C.M. Deshmukh and C.P. Pise, Analysis and Comparative Study of Composite Bridge Girders. International Journal of Civil Engineering and Technology , 7(3), 2016, pp.354 364. – ttp://iaeme.com/Home/issue/IJCIET?Volume=7&Issue=3 h 1. INTRODUCTION T-beam, used in construction, is a load-bearing structure of reinforced concrete, Wood or metal, with a t-shaped cross section. The top of the T-shaped cross section serves as a flange or compression member in resisting compressive stresses. The web of the