Adhesive Bonded Joints
Aim:- To test, fabricate, and analyze the failure of adhesive
bonded joints
Ansys Procedure Steps:-
Selection of Element TypeElement type solid- quad four node
42-element plane stress with thickness
Selection of Material PropertiesProperties- linear-elastic-
isotropic-give the values of youngs modulus and poison ratio-non
linear-inelastic-rate independent-kinematic hardening
plasticity-misses Plasticity-bi linear-yield stress=110
Modeling of MaterialMaterial-new model-orthotropic-X Y Z, XY YZ
ZX & Txy Tyz Txz Modeling-create-areas-rectangle-by
dimensionsXY0 1500 5100250-5-10100150-50Meshing-mesh
attribute-picked areas-select areas-element type plane 42-select up
and down areas-OK-select middle areas-OKModeling
operate-boolean-glue-area
Meshing of ModelMeshing-mesh tools-select entire area-OK
Application of loadSolution-define
load-apply-structural-displacement-on lines-left most horizontal
line-All DOF-OKSolution-pressure-on line-(-100) - OK
SolutionSolutions-o/p control-solution printout-every sub
stepSolution -o/p control-DB/result file-every sub
stepSolution-solution control-OKSolution-time/frequency-time and
sub steps -No. of sub steps=100