This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
intact. Position the Counter Sections as shown and secure together with 2-1/2" thumbturn bolts, washers and wingnut fasteners detailed below right.
2. Slide the Frame Posts into the Stand- Collars and secure with the 3" thumbturn bolt and wingnut fasteners detailed at right.
3. The Corner Brackets on the Counter Frames secure with 3/4" round-head bolts at 2 places each Bracket. These Brackets remain attached to the Counter Frame and should not be removed for packing.
Fastener Detail
Slide Post into Collar-Stand and Secure with 1/4-20x3" ThumbturnBolt and Wing Nut Fasteners at1 Location each.
Fastener Detail
Secure the 3 Counters together at 4places with 1/4-20x 2-1/2" ThumbturnBolt, 2 Washers and Wing Nut Fasteners.
KA
KC
KB
To Engage:Line-Up Drill Hole WithBullet Plunger, DepressBullet and Push MetalTube onto Connector.
To Disengage:Depress BulletPlunger and PullMetal Tube FromConnector.
Typical Snap-Fit Bullet Connectors
Posts Slide intoStand Collars andSecure in-Place
Please Note that the Shelf Panels and BasePanels remain attachedto the Counter Sectionsbut are Not Shown for Clarity.
CanopyCover-CntrWrapAssy_6-14SF 49ers Stadium Management Co.Custom Outdoor Kiosk Display_Canopy Cover-Counter Wrap AssemblyCanopy Assembly1. Attach Canopy Cover to top of Canopy Frame. The
underside of the Cover has Corner Pockets that slide onto the Corner Canopy Frame.
2. Attach the Cover to the top corners then, carefully pull the Cover down over the Bottom Canopy Corner Frames.
Attaching Canopy Cover3. Slide Cover Corner Pockets onto top of Corner Frame to
secure. Then slide Bottom Corner Pockets onto Corner Frames.
Attaching Header Fabric-Graphic4. Velcro the Fabric Graphic to the 1-1/4" Tubular Rails.Counter Fabric Wrap Assembly5. Velcro the Fabric Wrap to the Counter perimeter Frame as
shown. Begin at the back corner and slowly work around to the opposite side. Note that the Counter Tops are not shown but remain attached to the Counter Sections.
Metal Bench Assembly6. Secure Metal Bench to Counter Frames at 4 places shown
thru clearance holes in Fabric Wrap with 3" Thumbturn bolts with WingNut fasteners.
Fastener Detail
Secure Metal Bench to CounterFraming with 1/4-20x3" ThumbturnBolt and Wing Nut Fasteners at4 Locations.
Eyelet Strap falls on both sides ofTubular Rail. Thread Cable-Tie thruboth Eyelets to secure Canopy Coverto Tubular Framing. Eyelet Strapsoccur at 5 locations.
Strap / Cable -Tie
1-Piece CanopyCover
Canopy CornerPocket for Frame
Canopy CornerPocket for Frame
Bench-CushionSecured to Frame
Bench FrameIsometric ViewPlease Note that the Counter Tops, ShelfPanels and Base Panels remain attached to theCounter Sections but are Not Shown for Clarity.
Velco Counter FabricWrap to Counter Topand Bottom FramePerimeter