THE RELAY SPECIALISTS relay monitoring systems pty ltd www.rmpl.com.au 2V75 Metrosil / Resistor Module
Welcome message from author
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
THE RELAY SPECIALISTS
relay monitoring systems pty ltd www.rmpl.com.au
2V75Metrosil / Resistor Module
2V75Metrosil / Resistor Module
2V75Metrosil / Resistor Module
The 2V75 Metrosil module is designed for application with numeric or static high impedance differential and restricted earth fault protection schemes.
The 2V75 Module provides a compact, simple & cost effective means of fitting a pre-wired Metrosil & resistor combination into protection panels employing high impedance differential schemes.
2V75Metrosil / Resistor Module
Fully insulated module
Simple mounting & wiring
High energy absorption rating
Pre-wired with heavy duty stud terminals
High thermal rating
2V75Metrosil / Resistor Module
Metrosil + stabilizing resister version
Metrosil only version
3 or 6 inch Metrosils
Stabilizing resistor only version
Access for stabilizing resistor adjustment
100 or 200W stabilizing resistors
Single or three phase models
2V75Metrosil / Resistor Module
19 Inch Rack Mounting4U high, half width (Size 8) module
Space for DAD-N numeric high impedance
differential relay
Front Panel
Mounting Plate(Shown from front of panel after label removed)
Mounting Plate(Shown from rear of panel)
2V75 Module
Loading Module Onto Mounting Plate
Mounting Configuration
Securing Module to Mounting Plate
Rear Panel
Access to Adjust Stabilizing Resistors
Access to Adjust Stabilizing Resistors
Access to Adjust Stabilizing Resistors
Customer Generated Ordering CodeGenerate the required ordering code as follows: e.g. 2V75 ABABB 1 2 3 4 5
2V75 1 METROSIL SIZE A 152mm (Six inch) B 76mm (Three inch) C Not required (Resistors only fitted) 2 STABILIZING RESISTOR VALUE A Not required (Metrosil only fitted) B Required – 500 Ohms C Required – 1K Ohms D Required – 220 Ohms S Required – Specify value: ________ Ohm 3 MOUNTING HARDWARE A Rack or panel mount configuration B Rear cubicle surface mount (Module & bracket only) 4 STABILIZING RESISTOR POWER RATING A Not required (Metrosil only fitted) B 100W at nominal resistance C 200W at nominal resistance 5 NUMBER OF PHASES A Single phase B Three phase
2V75Additional Information
Technical BulletinUser GuideAuto Cad Mounting DrawingsPrice & Availability
www.rmspl.com.au/2V75.htm
Test Manuals
www.rmspl.com.au/search.asp
Other Products
www.rmspl.com.au/Products.htm
Related Documents
