Page 1 of 5 Diane Burton, STEM Outreach. [email protected]123D Design Tutorial: LED decoration Before using these instructions, it is very helpful to watch this video screencast of the CAD drawing actually being done in the software. Click this link for the video instructions Select ‘Sketch Spline’ Start drawing your shape left clicking each time you want to place a node on the shape (nodes can be moved later to allow you to change the shape slightly. Use Construct Extrude to extrude the shape to a height of 4mm SAVE YOUR WORK! You must finish your drawing at the same place you started to close the sketch. When you’ve done, this left click then press Enter to exit the sketch Your sketch should turn blue as below.
5
Embed
123D Design Tutorial LED decoration Before using these ...
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Before using these instructions, it is very helpful to watch this video screencast of the CAD drawing actually being done in the software. Click this link for the video instructions