1 CCNA 4 v3.1 Module 5. 2 CCNA 4 v3.0 Module 5 Frame Relay.

1

CCNA 4 v3.1 Module 5

2

CCNA 4 v3.0 Module 5 Frame Relay

333

Purpose of This PowerPoint

• This PowerPoint primarily consists of the Target Indicators (TIs) of this module in CCNA version 3.0.

• It was created to give instructors a PowerPoint to take and modify as their own.

• This PowerPoint is:

NOT a study guide for the module final assessment.

NOT a study guide for the CCNA certification exam.

• Please report any mistakes you find in this PowerPoint by using the Academy Connection Help link.

444

To Locate Instructional Resource Materials on Academy Connection:

• Go to the Community FTP Center to locate materials created by the instructor community

• Go to the Tools section

• Go to the Alpha Preview section

• Go to the Community link under Resources

• See the resources available on the Class home page for classes you are offering

• Search http://www.cisco.com

• Contact your parent academy!

555

Objectives

• Frame Relay concepts

• Configuring Frame Relay

666

Frame Relay Operation

777

Frame Relay Switches

888

Frame Relay Concepts

999

Local Significance of DLCIs

The data-link connection identifier (DLCI) is stored in the Address field of every frame transmitted.

101010

Terminology

• The connection through the Frame Relay network between two DTEs is called a virtual circuit (VC).

• Virtual circuits may be established dynamically by sending signaling messages to the network. In this case they are called switched virtual circuits (SVCs).

111111

Frame Relay Stack Layered Support

121212

Frame Relay Functions

131313

Bandwidth and Flow Control

Bit counter Example 1

141414

Frame Relay Concepts

151515

LAPF Frame

161616

Full-Mesh Topology

171717

Frame Relay Mesh

181818

LMI

• Three types of LMIs are supported by Cisco routers:

Cisco — The original LMI extensions

Ansi — Corresponding to the ANSI standard T1.617 Annex D

q933a — Corresponding to the ITU standard Q933 Annex A

191919

Stages of Inverse ARP and LMI Operation #1

202020

Stages of Inverse ARP and LMI Operation #2

212121

Configuring Basic Frame Relay

222222

Configuring a Static Frame Relay Map

232323

Reachability Issues with Routing Updates in NBMA

By default, a Frame Relay network provides nonbroadcast multiaccess (NBMA) connectivity between remote sites. An NBMA environment is treated like other multiaccess media environments, where all the routers are on the same subnet.

242424

Frame Relay Subinterfaces

252525

Configuring Point-to-Point Subinterfaces

262626

Verifying Frame Relay

• The show interfaces command displays information regarding the encapsulation and Layer 1 and Layer 2 status. It also displays information about the following:

The LMI type

The LMI DLCI

The Frame Relay data terminal equipment/data circuit-terminating equipment (DTE/DCE) type

272727

The show frame-relay lmi Command

282828

The show frame-relay pvc Command

292929

The show frame-relay map Command

303030

Troubleshooting Frame Relay

• Use the debug frame-relay lmi command to determine whether the router and the Frame Relay switch are sending and receiving LMI packets properly.