1 CCNA 4 v3.1 Module 4. 2 CCNA 4 v3.0 Module 4 ISDN and DDR.

1

CCNA 4 v3.1 Module 4

2

CCNA 4 v3.0 Module 4ISDN and DDR

333

Objectives

• ISDN concepts

• ISDN configuration

• DDR configuration

444

Digital Communication with ISDN

555

ISDN Benefits

666

ISDN Standards

777

ISDN Access Options

888

ISDN 3-Layer Model

999

Q.931 Messaging-Call Setup Example

101010

Call Processing

1. The D channel is used to send the called number to the local ISDN switch.

2. The local switch uses the SS7 signaling protocol to set up a path and pass the called number to the remote ISDN switch.

3. The remote ISDN switch signals the destination over the D channel.

4. The destination ISDN NT-1 device sends the remote ISDN switch a call-connect message.

5. The remote ISDN switch uses SS7 to send a call-connect message to the local switch.

6. The local ISDN switch connects one B channel end-to-end, leaving the other B channel available for a new conversation or data transfer. Both B channels can be used simultaneously.

111111

ISDN Functions and Reference Points

121212

ISDN Functions and Reference Points

131313

BRI Reference Points

141414

Cisco ISDN BRI Interfaces

151515

ISDN Interfaces

S/T ISDN Interface

U ISDN Interface

161616

ISDN Switch Types

171717

Configuring ISDN BRI

181818

Configuring ISDN BRI

191919

Configuring ISDN PRI

202020

Switch Types Available for ISDN PRI Configuration

212121

ISDN PRI Examples

222222

Verifying ISDN Configuration

232323

Troubleshooting ISDN Configuration

242424

DDR Operation

252525

DDR Operation

262626

Configuring Legacy DDR

272727

Defining Static Routes

• When configuring static routes, consider the following:

By default, a static route will take precedence over a dynamic route because of its lower administrative distance. Without additional configuration, a dynamic route to a network will be ignored if a static route is present in the routing table for the same network.

To reduce the number of static route entries, define a summarized or default static route

282828

Specifying Interesting Traffic – Dialer List

292929

Configuring Dialer Information – PPP

303030

The dialer-group Command

313131

The dialer-map Command

323232

The dialer idle-timeout Command

333333

Dialer Profiles Overview

• Define encapsulation and access control lists

• Determine minimum or maximum calls

• Turn features on or off

343434

Dialer Profile Elements

353535

Configuring Dialer Interfaces

363636

Verifying DDR

• show dialer

• show dialer interface [BRI]

• show isdn active

• show isdn status

373737

Troubleshooting DDR

• debug isdn q921

• debug isdn q931

• debug dialer [events|packets]

• isdn call interface

• clear interface bri