Written By: Ben Barber - the-eye.eu Guides/Canon... · Canon AE-1 Film Rewind Crank Replacement It is possible after use or damage that the film rewind crank could become damaged

Canon AE-1 Film Rewind Crank ReplacementIt is possible after use or damage that the film rewind crank could become damaged or broken.

This guide will give you the steps needed to replace the film rewind crank.

Written By: Ben Barber

Canon AE-1 Film Rewind Crank Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5

TOOLS:Phillips #00 Screwdriver (1)

Flathead 3/32" or 2.5 mm Screwdriver (1)

PARTS:Replacement film rewind crank (1)

Canon AE-1 Film Rewind Crank Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5

Step 1 — Film Rewind Crank

Open film door

Place screwdriver in slot as shown

Step 2

Use screwdriver to prevent shaftfrom turning

Rotate crank counter clockwise toremove crank

Canon AE-1 Film Rewind Crank Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5

To reassemble your device, follow these instructions in reverse order.

Step 3

Remove the two screws

Remove silver pate

Step 4

Remove film rewind crank

Canon AE-1 Film Rewind Crank Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5

This document was last generated on 2017-06-21 09:05:33 PM.

Canon AE-1 Film Rewind Crank Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5