FORD FIESTA ST - WING RISER - Boomba Racing FIESTA ST - WING RISER.pdf · FORD FIESTA ST WING RISER 8 Pull the wing toward back of the car to detach the wing from the hatch. 9 Remove

FORD FIESTA ST

WING RISER

8

Pull the wing toward back of the car todetach the wing from the hatch.

9

Remove all locating and latching clipsfrom the wing by sliding them to the side.

10

Attach the center risers to the wing withthe provided M6 socket head cup screws.Tighten the screws slightly so the risersstays in place but can be moved by handduring adjustment.

11

Attach the right side risers to the wingwith the provided #8 Phillps head screws.Do not use power tools.Tighten the screws slightly so the risersstays in place but can be moved by handduring adjustment.

12

Attach the left side risers to the wing withthe provided #8 Phillps head screws.Do not use power tools.Tighten the screws slightly so the risersstays in place but can be moved by handduring adjustment.

MATERIALS REQUIRED

None

TOOLS REQUIRED

M8 socket wrenchM5.5 (7/32) socketT20 Torx bitM5 Allen wrenchPhillips screw driver

Wire cuttersHeat gun

1

Remove plastic vacuum hose from rubberadaptor on the top of valve cover (leaverubber adaptor in place).1

Remove the antenna.

2Remove the stop light’s screws. Removethe stop light.

3

Disconnect the wire harness. Disconnectthe windshield washer fluid line.

4

Remove the trim caps. Disconnect theshelf lanyards.

5

Remove the left side wing screws.Do not use power tools. Using power toolsmay damage the threads. 6

Remove the right side wing screws.Do not use power tools. Using power toolsmay damage the threads. 7

Remove the center wing screws.

1Remove plastic vacuum hose from rubberadaptor on the top of valve cover (leaverubber adaptor in place).13Close the plastic clips holes with providedstickers.

14

Line up the wing with the hatch and thecenter risers with the holes in the hatch.Move the risers if necessary. Use factoryscrews to secure the risers to the hatch.Finger tight only.

15

Line up the left side risers with the holesin the hatch. Move the risers if necessary.Use provided M5 screws and washers tosecure the risers to the hatch.Finger tight only.

16

Line up the right side risers with the holesin the hatch. Move the risers if necessary.Use provided M5 screws and washers tosecure the risers to the hatch.Finger tight only..

17

Remove the wing from the hatch carefullywithout changing the risers position.Secure the center risers to the wing firmly. 18

Secure the right side risers to the wingfirmly.Do not use power tools. 19

Secure the left side risers to the wingfirmly.Do not use power tools. 20

Install the wing and secure it firmly to thehatch.

21

Connect and reinstall the stop light.

22

Cut of 2 1/4” (60 mm) from the end of theantenna.

23

Place provided heat shrink cap over thetip of the antenna.

24

Install the antenna. Open the hatch andcheck for the interference. Trim more ifnecessary. If there is no interference heatcap with the heat gun to secure it to theantenna.

25

Heat cap with the heat gun to secure it tothe antenna.

26

Install the ntenna