CSCF IFC Trigger Point Mode Commands€¦ · CSCF IFC Trigger Point Mode Commands TheCSCFiFCTriggerPointConfigurationModeisusedtoassociateanInitialFilterCriteria(iFC)Service PointTrigger(SPT
Post on 20-Jul-2020
21 Views
Preview:
Transcript
CSCF IFC Trigger Point Mode Commands
The CSCF iFC Trigger Point Configuration Mode is used to associate an Initial Filter Criteria (iFC) ServicePoint Trigger (SPT) group with an iFC trigger point.
Command Modes Exec > Global Configuration > Context Configuration > CSCF IFC Trigger Point Configuration
configure > context context_name > cscf ifc-trigger-point id trigger_point_id condition-type { cnf | dnf}
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-cscf-ifc-trigger-point)#
The commands or keywords/variables that are available are dependent on platform type, product version,and installed license(s).
Important
• end, page 2
• exit, page 3
• spt-group, page 4
Command Line Interface Reference, Commands C - D, StarOS Release 20 1
endExits the current configuration mode and returns to the Exec mode.
Product All
Privilege Security Administrator, Administrator
Syntax Description end
Usage Guidelines Use this command to return to the Exec mode.
Command Line Interface Reference, Commands C - D, StarOS Release 202
CSCF IFC Trigger Point Mode Commandsend
exitExits the current mode and returns to the parent configuration mode.
Product All
Privilege Security Administrator, Administrator
Syntax Description exit
Usage Guidelines Use this command to return to the parent configuration mode.
Command Line Interface Reference, Commands C - D, StarOS Release 20 3
CSCF IFC Trigger Point Mode Commandsexit
spt-groupAssigns an existing iFC SPT group to an iFC trigger point.
Product SCM (S-CSCF, SIP Proxy)
Privilege Administrator
Command Modes Exec > Global Configuration > Context Configuration > CSCF IFC Trigger Point Configuration
configure > context context_name > cscf ifc-trigger-point id trigger_point_id condition-type { cnf | dnf }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-cscf-ifc-trigger-point)#
Syntax Description [ no ] spt-group id group_id
no
Removes the specified CSCF iFC SPT group from the iFC trigger point.
spt-group id group_id
Specifies the ID of an existing iFC SPT group.
group_id must be an integer from 1 to 200.
An iFC SPT group can be assigned to more than one iFC trigger point.Important
Usage Guidelines Use this command to associate an iFC SPT group with an iFC trigger point.
Examples The following command assigns iFC SPT group 2 to an iFC trigger point:spt-group id 2
Command Line Interface Reference, Commands C - D, StarOS Release 204
CSCF IFC Trigger Point Mode Commandsspt-group
top related