CSCF IFC Trigger Point Mode Commands The CSCF iFC Trigger Point Configuration Mode is used to associate an Initial Filter Criteria (iFC) Service Point Trigger (SPT) group with an iFC trigger point. Command Modes Exec > Global Configuration > Context Configuration > CSCF IFC Trigger Point Configuration configure > context context_name > cscf ifc-trigger-point id trigger_point_id condition-type { cnf | dnf } Entering the above command sequence results in the following prompt: [context_name]host_name(config-cscf-ifc-trigger-point)# The commands or keywords/variables that are available are dependent on platform type, product version, and installed license(s). Important • end, page 2 • exit, page 3 • spt-group, page 4 Command Line Interface Reference, Commands C - D, StarOS Release 20 1
4
Embed
CSCF IFC Trigger Point Mode Commands€¦ · CSCF IFC Trigger Point Mode Commands TheCSCFiFCTriggerPointConfigurationModeisusedtoassociateanInitialFilterCriteria(iFC)Service PointTrigger(SPT
This document is posted to help you gain knowledge. Please leave a comment to let me know what you think about it! Share it to your friends and learn new things together.
Transcript
CSCF IFC Trigger Point Mode Commands
The CSCF iFC Trigger Point Configuration Mode is used to associate an Initial Filter Criteria (iFC) ServicePoint Trigger (SPT) group with an iFC trigger point.
Command Modes Exec > Global Configuration > Context Configuration > CSCF IFC Trigger Point Configuration