Accessing the Installer’s Menu

Accessing the Installer’s Menu

The entire cycle

Enrolling a Device

• To enroll a device means to link a device to the controller, eg, enroll a wired contact, enroll a wireless sensor, etc

• When asked to Delete using the OFF key,Use the Disarm button

• Once a device is enrolled, the controller can detect it.

• If you have enrolled the magnetic contacts, open the contacts and observe what is displayed on the LCD display, such as,

“ Back Door Open”

Observe this• After Enroll

How to delete

Observe this After Delete

Perform Diagnostic Test of Wireless Devices

Fail

PASS

10. Diagnostics WL Sensors Test

Front Door Z01 NOT-OK

Diag. Testing

Open door

Front Door Z01 STRONGOpen door

How to change Zone Type

How to change Zone Name

How to change Chime

3. Define Zone Zone no:

Z01: TYPE -- 2. Perimeter

Zone No : 0101

Done!

Z01: NAME -- Back door Done!

Z01: CHIME Chime OFF Done!

Z01: PARTITION Partition 1Done!

Enrol Proximity Tag

• Enrol Enrol Prog Tag <ok>• Tag No 1 <ok> Present Tag: Tag

No 1 <next>• To return clich “home” <ok> to exit

Define Control Panel

• Installer Mode <next>

• Define Panel <Ok>

• Entry Delay 1

Observation

After Enroll After Delete

How to stop alarm

Panel Buttons

What different Arm means

How to Arm Away

How to Arm Home

From Installer Manual

Basic

Warning !