Design of Crane Runway Beam with Channel Cap DUANE S. ELLIFRITT and DUNG-MYAU LUE INTRODUCTION A common practice in industrial buildings is to weld a channel, open side down,…
Optics and Lasers in Engineering 27 (1997) 61-13 Copyright 0 1996 Elsevier Science Limited Printed in Northern Ireland. All rights reserved 0143~8166/97/$17~00 ELSEVIER PII:…
The API 579 Fitness-for-Service Standard – The Current State of Technology and a Ten Year Look Ahead 10th Annual IPEIA (formerly NPEC) Conference Banff Centre in Banff…
Fundamentals of Metal Fatigue: Stress life method -- plots of alternating stress, S, vs. cycles to failure, N. • ignores true stress and strain (assumes elastic strains)…
Centrifugal Pump Set Failure Modes and Causes Pump Set failure modes Pump Set failure mechanism No Liquid Delivered Pump not primed Liquid returned backward Suction valve…
Effects of Temperature and Strain Rate on the Tensile Behavior of Unfilled and Talc-Filled Polypropylene. Part I: Experiments YUANXIN ZHOU and P. K. MALLICK Centerfor Lightweighting…
Practical Guide to Rotational Moulding Roy J. Crawford and Mark P. Kearns Practical Guide to Rotational Moulding by R.J. Crawford and M.P. Kearns Queen’s University, Belfast…
Health & Safety Executive HSE Steel OFFSHORE TECHNOLOGY REPORT 2001/015 Health & Safety Executive HSE Steel Edited under the HSE Technical Support Agreement by BOMEL…
Manufacturing Process· I 203 3.4 EXTRUSI N Extrusion may be defined as the forming of a material under compression, so that it is f~ced to flow out of a confined space through…